Catalogs >
NEURTEK >
Impact tester for paint

Impact tester for paint
2Pages

Catalog excerpts

Impact Tester Quality Control Instruments neurtek"!instruments Impact tester for coatings The Impact Tester is used for measuring the resistance of coatings to impact. Thanks to it you can simulate the production of cracks and peeling, resistance to shocks, the flexibility, adherence and elongation of coatings. If you have a standard to comply with, just place the mass at the indicated height and release it. Then, check visually for possible cracks. To check the resistance of a coating, you can continue testing by gradually increasing the height until the mass produces cracks on the sample. The Impact Tester comes with a support base, ruled tube and an impact mass equipped with a holding device according to the required standard - (for specific accessories, see table below). 0304025 Stop ring collar and sample clamp for weight release Impact Mass 900 gr. Extra Weight 120 gr. Ball 0 15,9 mm with screw, without ball NEURTEK S.A. ALL RIGHTS RESERVED. TECHNICAL DATA SUBJECT TO CHANGE WITHOUT NOTICE. Static Weight 360 gr. Ball 22 mm

Open the catalog to page 1

Impact Tester Quality Control Instruments Conversion Kits Reference 0304021 Supply To convert 0304020 into UNE-EN-ISO 6272-2 (0304030) NEURTEK S.A. ALL RIGHTS RESERVED. TECHNICAL DATA SUBJECT TO CHANGE WITHOUT NOTICE.  Static Weight 150 gr. Ball 15,9  Die ø16,3 To convert 0304020 into ASTM D-2794 (0304040)  Impact Mass 900 gr. Ball 15,9  Extra Weight 120 gr. with screw and without ball  Die ø16,3 To convert 0304030 into UNE-EN-ISO 6272-1/DIN55669 (0304020)  Die ø27 To convert 0304030 into ASTM D-2794 (0304040)  Weight 900 gr. Ball 15,9  Extra Weight 120 gr. with screw and without...

Open the catalog to page 2

Impact tester for paint 2Pages

Catalog excerpts

All NEURTEK catalogs and technical brochures

Impact tester for paint
2Pages