neurtek"! instruments Cross Hatch Adhesion TesterYour quality control instruments providerApplication Adhesion Tester appropriated to measure the adhesion of coatings or paints. Designed and made by NEURTEK. The cross cut test uses a blade to cut through the coating to the substrate. At least two cuts are made that intersect at 90 degrees to get a right angle lattice pattern. The cross-cut area is observed for any adhesion failure. After applying a normalized adhesive tape the resistance to separation can be observed on the tape by using a loupe. Complies with the following standards ISO 2409, ASTM D 3359, DIN 53151. Certificate of calibration ZPEX020 Calibration Cross Hatch-Cutter -1 unit, with traceability. Ordering information I OSCILLATING HEAD BRUSH_ Cross-cut kits including holder, brush, loupe and tape for normalized adhesion according ISO 2409 and choose separately the cutter which fits with your requirements. Test Kits and Holders: Referencia Modelo 0302000 Cross-cut kit NK2000 with 3D holder 0302008 3D holder for cross-cut adhesion test 0302009 Cross-cut kit NK2000 with poliamida holder 0302007 Poliamida holder for cross-cut adhesion test NEURTEK S.A. SE RESERVA EL DERECHO DE MODIFICACION SIN PREVIO AVISO. Cutter blade: Reference_Model_ 0302001 Round Blade 1 mm, 6 cuts, (0-60 pm) thickness 0302002 Round Blade 2 mm, 6 cuts, (60-120 pm) thickness 0302003 Round Blade 2 mm, 6 cuts, (121-250 pm) thickness 0302004 Round Blade 4 mm, de 5 cuts, (thickness >250 pm) 0302005 Round Blade 1mm, 11 cuts - special application Adhesive Tape: Reference Model 0302010 Adhesive Tape (old standard) 10N/25mm (33metros x 25 mm) 0302013 Adhesive Tape - (77N/100 mm) - FORD 0302014 Adhesive Tape 2525 - Renault 0302015 Adhesive Tape 4651 - Opel 0302016 Adhesive Tape 4657 - Volkswagen