Catalog excerpts
Precision Position Sensors ABSOLUTE POSITION ROTARY ELECTRIC ENCODER1" HARSH ENVIRONMENT VLP-100 Cf core DATA SHEET The VLP-100 is a member of the VLP series of Electric Encoders™ a product line based on Netzer Precision Position Sensor proprietary technology. EE products are characterized by features that enable unparalleled performance: • Low profile (<7 mm) • Hollow shaft (Stator / Rotor) • No bearings or other contact elements • High resolution and unparalleled precision • High tolerance to temperature extremes, shock, moisture, EMI, RFI and magnetic fields • Very low weight • Holistic signal generation • Digital interfaces for absolute position
Open the catalog to page 1
Precision Position Sensors ABSOLUTE POSITION ROTARY ELECTRIC ENCODER1" HARSH ENVIRONMENT VLP-100 Cf core DATA SHEET Digital SSi Interface SSi / BiSS output signal parameters Synchronous Serial Interface (SSi) is a point to point serial interface standard between a master (e.g. controller) and a slave (e.g. sensor) for digital data transmission. Tr Output code Digital BiSS-C Interface BiSS - C Interface is unidirectional serial synchronous protocol for digital data transmission where the Encoder acts as “slave” transmits data according to “Master” clock. The BiSS protocol is designed in B...
Open the catalog to page 2
ABSOLUTE POSITION ROTARY ELECTRIC ENCODER HARSH ENVIRONMENT Outer Diameter Extended Accuracy Netzer Cat No.: CB-00100 Cable: 30 AWG twisted pair (3) (30 AWG 25/0.05 tinned copper, Insulation: ETFE Ø 0.12-0.15 to Ø 0.6 ± 0.05 OD) Temperature rating: -60° to +150° C Braided shield: Thinned copper braided 95% min. coverage Jacket: 0.4-0.5 silicon rubber Ø3.45 ±0.2 OD 0 250mm Flying leads (default) Gray / Blue Green / Yellow Resolution Code DATA SHEET Cable Information Braided shield Jacket 0.4- 0 . 5 mm BIT (Build In Test): optional [] Related Documents VLP-100 User Manual: Mechanical,...
Open the catalog to page 3
Netzer Precision Position Sensors ABSOLUTE POSITION ROTARY ELECTRIC ENCODER™ HARSH ENVIRONMENT VLP-100 icore DATA SHEET 100 STATOR O.D048 ROTOR ID 1. Due to pcb's inherent manufacturing tolerances, Netzer recomends the use of shims in order to achieve the desired air gap. 2.Other than the mount, allow at least 1 mm gap under the rotor, free of any metal. Unless Otherwise Specified
Open the catalog to page 4
