Catalogs >
NB Europe >
LEAFLET OF SHAFT DRAWINGS

LEAFLET OF SHAFT DRAWINGS
9Pages

Catalog excerpts

NIPPON BEARING CO.,LTD. 939 ACE. Drive. Wood Dale.lL 60191 Western Regional Office 21S7 O'Toote Ave.Sulte D.San Joso.CA 95131 Eastern Regional Office 41 Orchard Slrool Pnmsov.NJ 07446 http://www nbcoiporatlon.com into ft nbcorpor otion com Specifications are subject lo change without nooce. LEAFLET OF SHAFT DRAWINGS SLIDE SHAFT SPINDLE SHAFT ROLL SHAFT GENERAL MACHINERY SHAFT Please use this leaflet as a guideline to explore your machining requirements. NIPPON BEARING CO.,LTD.

Open the catalog to page 1

This drawing is example of machining. internal taper grinding are available up to NT50 maximum internal diameter is ^400mm nspeclion data is necessary (or compatible to partrwr parts screw grinding is available within maximum span 1000mm ■prevention ol cartxjrizing is available • hardness of curbuhzing is HRC62 */- 2 and rt'S depth is 1.5 to 2mm material experience

Open the catalog to page 2

SPINDLE SLEEVE This drawing is example of machining maximum internal grinding 300mm | maximum outer diameter 1350mm material experience

Open the catalog to page 4

This drawing is example of machining. 110 depth 20 6-^18 drill through

Open the catalog to page 5

This drawing is example of machining. 'sleo for thermal-spraying ceramic detail drawing of thermal-spraying ceramic range -----surface roughness RaaQ4a or lower after thermal-spraying

Open the catalog to page 6

NIPPON BEARING CO.,LTD. This drawing is example of machining. maximum outer diameter ^340mm ----hardness :Hs92+/-2, effective hardness depth 3mm or more ^180 portion hard chrome plating with grinding, depth 30—40^m plating hardness HV900 or more

Open the catalog to page 7

This drawing is example of machining. (from the back side) (circumference equal angle) maximum length 6000mm (without flat) *----induction hardening and tempering

Open the catalog to page 8

List of shaft machining specifications In most cases, slide shafts, spindle shafts, and roll shafts require machining. The following charts show a range of machining. Machining example sheets shall give a better idea about NB's machining ability and skills that should meet customers' expectations. SLIDE SHAFT SPINDLE SHAFT ROLL SHAFT GENERAL MACHINERY SHAFT customer request outer diameter g6 or io be specified g6 or lo be specified) g6 or to be specified g6 or to be specified a range and specifications of machining maximum dometer — maximum length surface roughness — o internal surface...

Open the catalog to page 9