Catalogs >
Nanjing AH Electronic Science and Technology Co., Ltd. >
Omnipolar Hall sensor AH3662 (Latch Type)

Omnipolar Hall sensor AH3662 (Latch Type)
8Pages

Catalog excerpts

Omnipolar Hall sensor AH3662 (Latch Type) - 1

Digital Micropower Omnipolar Hall IC △ Digital output, omnipolar latch △ Automotive electronics, Consumer electronics and Industrial electronics △ Water flow sensing △ Liquid level detection △ Position sensing △ Hand-held equipment (Cellphone, Pan-Tilt, Notebook, etc.) △ Contactless key/button △ Bluetooth headset △ Door latch system △ Stable over the entire temperature range △ Low operating voltage range: 2.5V ~ 5.5V △ Strong resistance to mechanical stress △ Non-contact output, safety and reliable △ Operating temperature range: -40℃ ~ 85℃ △ TO-92UA and SOT-23-3L package options △ Developed according to the EU RoHS and REACH 3 Selection Guide Part Number Mounting 3-pin SOT23-3L surface mount 3-pin SIP through hole NOTE 1. Hall ICs are soldered tin brazing for assembly, and wave soldering of SOT-23-3L surface-mounted components poses a risk of failure. 2. A risk of circuit failure may happen in non-brazing processes such as electric resistance welding, high-frequency welding, etc. 3. E: -40~85°C; K: -40~125°C; L: -40~150°C. Nanjing AH Electronic Science & Technology Co., Ltd. ADD: Building 3, Huaye Park, Qidi City, 8, Zhineng Roa

Open the catalog to page 1

Omnipolar Hall sensor AH3662 (Latch Type) - 2

Digital Micropower Omnipolar Hall IC 4 General Description The AH3662 is a digital omnipolar-latch Hall IC with single output. It has good temperature stability and operates over a temperature range of -40°C to 85°C with latch function. The AH3662 Hall-effect sensor includes the following on a single silicon chip: reverse voltage protector, voltage regulator, temperature compensation circuit, Hall-voltage generator, signal amplifier, Schmitt trigger, open-drain output driver and built-in pull-up resistor, etc. The AH3662, produced with CMOS technology, is asked for lower supply voltage and...

Open the catalog to page 2

Omnipolar Hall sensor AH3662 (Latch Type) - 3

Digital Micropower Omnipolar Hall IC 6 Absolute Maximum Ratings Characteristic Supply Voltage Output Current Symbol IOUTSINK Magnetic Flux Density Operating Temperature E Too high a Tj could lead to electrical or thermal breakdown Maximum Junction Temperature Storage Temperature NOTE 1. Human Body Model according to AEC-Q100-002 standard. 7 Electrical Operating Characteristics valid through the full operating temperature range; unless otherwise specified Test Conditions Supply Voltage High-level Output Voltage Low-level Output Voltage Average Supply Current Awake Supply Current Sleepy...

Open the catalog to page 3

Omnipolar Hall sensor AH3662 (Latch Type) - 4

Digital Micropower Omnipolar Hall IC 9 Magnetic Behavior When the magnet (S or N pole) is close to the sensor (|B|≥|BOP|), the sensor outputs a low level; when the magnet is far away from sensor (|B|≤|BRP|), the sensor outputs a high level. Steady Hysteresis (BHX=|BOPX- BRPX|) ensures its stable switch status. The magnetoelectric conversion characteristics of AH3662 are shown in the figure: Vout switch to high Vout switch to high Omnipolar Switch Nanjing AH Electronic Science & Technology Co., Ltd. ADD: Building 3, Huaye Park, Qidi City, 8, Zhineng Road, KyLin Technology Innovation Park,...

Open the catalog to page 4

Omnipolar Hall sensor AH3662 (Latch Type) - 5

Digital Micropower Omnipolar Hall IC Low Average Power Internal timing circuit activates the IC for 45 µs and deactivates it for the remainder of the period (45 ms). A short "awake" time allows for stabilization prior to the sampling and data latching on the falling edge of the timing pulse. The output during the "sleep" time is latched in the last sampled state. The supply current is not affected by the output state. IAWK Period Sleep Period Nanjing AH Electronic Science & Technology Co., Ltd. ADD: Building 3, Huaye Park, Qidi City, 8, Zhineng Road, KyLin Technology Innovation Park, Nanjing,

Open the catalog to page 5

Omnipolar Hall sensor AH3662 (Latch Type) - 6

Digital Micropower Omnipolar Hall IC Nanjing AH Electronic Science & Technology Co., Ltd. ADD: Building 3, Huaye Park, Qidi City, 8, Zhineng Road, KyLin Technology Innovation Park, Nanjing, C

Open the catalog to page 6

Omnipolar Hall sensor AH3662 (Latch Type) - 7

Digital Micropower Omnipolar Hall IC Nanjing AH Electronic Science & Technology Co., Ltd. ADD: Building 3, Huaye Park, Qidi City, 8, Zhineng Road, KyLin Technology Innovation Park, Nanjing, Ch

Open the catalog to page 7

Omnipolar Hall sensor AH3662 (Latch Type) - 8

Digital Micropower Omnipolar Hall IC Package form Operating temperature Device part number 3-pin digital omnipolar series with single output Nanjing AH Electronic Science & Technology Co., Ltd. ● Package Form: M —— SOT-23-3L（SMD） S —— SOT-89（SMD） UA —— TO-92UA/TO-92S（SIP） Note: M and S type are packed in reels, M 3k/reel, S 1k/reel; UA type is packed in bags of 1k/bag or 0.5k/bag. ● Operating Temperature: E —— -40℃～+85℃ L —— -40℃～+150℃ Copyright 2003~2020 Nanjing AH Electronic Science & Technology Co., Ltd. Nanjing AH Electronic Science & Technology Co., reserves the right to improve the...

Open the catalog to page 8