GETTING HELP Thank you for purchasing our product. For inquiries, do not hesitate to contact us: [email protected] For technical support, go to our website and submit a ticket: https://www.myscada.org/submit-ticket For more information, see the online manual on our website: https://www.myscada.org/mybox8-manual WARRANTY All products manufactured by mySCADA Technologies s.r.o.™ are under warranty (regarding defective materials) for a period of one year from the date of delivery to the original purchaser.

HARDWARE FEATURES Ethernet/Serial port Ethernet/Serial port Ethernet port Wifi/GPS Antenna output Micro SD card slot Power supply socket (12-36 V DC) Description DIN rail holder

PACKAGE CONTENT 1x myBOX, 1x package with necessary accessories for installation, 1x quick guide. FIRST BOOT Before you install and wire any device, make sure to disconnect the electric power from the system! Strip the ends of the cable so it could be slipped into the supplied green connector (as shown on the picture below). Do not forget to check the correct polarity! Tighten the terminal screw using a small flat-blade screwdriver. Plug electricity cable into myBOX which must be in the range 12~36 V DC. Ground Negative Positive When the wires are attached, plug in the green connector to the...

MOUNTING THE DEVICE The device can be mounted to EN50022-35×7.5 or EN50022-35×15 DIN rails. There is no need for using any screwdrivers or tools. Simply hook the top slot over the DIN rail and then, while pressing the device down against the top of the rail, snap the bottom of the device into position. To remove your controller from the DIN rail press the bottom jutting part of the holder (you may need a screw driver to do so) and release the device from the DIN rail by carefully pulling it up and towards you. The examples and diagrams in this manual are included solely for illustrative purposes....