Dual Range Heavy Duty Rinse Tank Control System IP65 /NEMA 4X Cuts Water Consumption up to 85% IP65 / NEMA 4X Rating Water and Corrosion Resistant Enclosure 316 Stainless Steel Hardware Reliable Solid-State Electronics Automatic Temperature Compensation to 25ºC/77ºF up to 82ºC/180ºF Valve features Anti-Hammer Closing and Conduit Connector, Adjustable Flow Control, and Manual Override • Continuous-flow rinse tanks • Circuit board manufacturing • Electroplating • Wastewater • Plus many more! 1. TRANSFORMER BOX Reduces line power to safe level for sensor and solenoid valve. 2. SOLENOID VALVE 1 in., corrosion-resistant with flow control and manual override. 24V for safety. The Myron L CONTROLSTIK II Rinse Tank System dramatically reduces the amount of water used in continuous flow rinse tanks. At the same time, it automatically maintains optimum water purity, ensuring effective rinsing. The three parts of the CONTROLSTIK II System are easily installed. The CONTROLSTIK II (conductivity sensor) is set at a tolerable contamination level and submerged in the tank. Water cannot flow into the tank until drag-in from rinsed parts causes the contamination level in the tank to rise above the pre-set point. The CONTROLSTIK II (sensor) then signals the solenoid valve to open, adding fresh water. As soon as this fresh water dilutes the contamination to the tolerable pre-set level, the CONTROLSTIK II (sensor) closes the valve. 3. CONTROLSTIK SENSOR Adjustable set-point minimizes tampering. Two ranges built-in for tap and purified water. Water Quality Instrumentation Accuracy •

ENGINEERING SPECIFICATIONS TRANSFORMER BOX Input Power Output Choice of 110 or 220 VAC, 50/60 Hz; Automatic voltage regulation insures operation of the systems from 105-125V or 210-250V respectively. 24 volts @ 600 mA AC Maximum Power Consumption @ 117V: 12 watts (103 milliamps) Enclosure IP65/NEMA 4X fiberglass case with heavy gasket and 316 stainless steel hardware. LEDs indicate POWER (red) and VALVE (yellow) Electrical Installation Either HARDWIRE with 5/8 in. conduit; or PLUG-IN with 8 ft./2,4 meter, 18 ga. 3-conductor plug. (supplied with 110V systems only) Mounting Flange on enclosure...