
Catalog excerpts

IDEALLY CONNECTED IN ALL ZONES MURRELEKTRONIK CORDSETS FOR THE FOOD INDUSTRY Processes and products in the food industry must be contamination free. That's why the requirements governing hygiene, cleanliness and corrosion protection are very high. Removing dirt easily and thoroughly is a top requirement for components. This applies to the food zone (1) as well as to the spray zone (2) and the non-food or dry zone (3). Murrelektronik has cordsets for all these applications within the food industry. MACHINE AREAS per DIN EN 1672-2 and ISO 14159 © Food zone © Spray zone © Non-food zone or dry zone Zones 1 and 2 must be designed in accordance with the same hygienic design principles
Open the catalog to page 1
In areas where every component in a system comes into contact with the food being processed, then re-enters the processing operation, the cordsets must be able to satisfy each and every cleana-bility requirement. The materials should neither absorb nor contaminate the product. The new M12 range from Murrelektronik, made of polypropylene, fulfills the very latest requirements of the EHEDG \ and are therefore suitable for use in these zones. RECOMMENDED FIELD OF APPLICATION ■ Zones 1 and 2 ■ Aseptic areas (H2O2) ■ Average cleaning processes ■ Intensive use of cleaning agents Produced from...
Open the catalog to page 2
M12 F&B STEEL In areas where plastic connectors reach their limits, M12 Steel is the right choice. Even if zones 1 and 2 are only high-pressure cleaned for short periods of time, this fully molded cordset made of stainless steel is the 'unbreakable' alternative. This stainless steel housing enables it to outperform the protection standards of IP69K. Permanently IP69K protected Stainless steel housing and parts made of V4A (1.4404) Cables made of FDA-compliant materials ■ Frequent cleaning processes ■ Intensive use of cleaning agents Length xxxx in cm Cables yyy: TPE-S - 336 PVC - 214
Open the catalog to page 3
M12 F&B PLUS The requirements defining cleanability, in regards to materials and design are not as stringent in downstream processes in the dry zone as they are in zones 1 and 2 because there isn't any direct contact possible with food. Here, M12 F&B Plus is the best solution. RECOMMENDED FIELD OF APPLICATION ■ Zones 2 and 3 ■ Normal cleaning processes ■ Low use of cleaning agents Innovative gasket and radial seal Integrated locking mechanism Tight seal even before correct torque is reached Permanent seal acc. to IP66K, even during shock and vibration This is only a small selection from our...
Open the catalog to page 4All MURRELEKTRONIK catalogs and technical brochures
-
INDUSTRIAL ETHERNET
3 Pages
-
F&B PRO
2 Pages
-
Ethernet Switch
2 Pages
-
GENERAL CATALOG
789 Pages
-
EMPARRO HD – HEAVY DUTY
2 Pages
-
ECO-RAIL-2
2 Pages
-
COMPACT FIELDBUS MODULES
2 Pages
-
MASI20
2 Pages
-
Mico Pro®
3 Pages
-
Exact12 ATEX
1 Pages
-
Engineering Excellence
2 Pages
-
Emparro67 Hybrid
2 Pages
-
Emparro67
2 Pages
-
Emparro MEF
2 Pages
-
Emparro Cap
2 Pages
-
Emparro 3-phase
4 Pages
-
Emparro
2 Pages
-
Demagnetizer
2 Pages
-
Cube67 Diagnostic Gateway
2 Pages
-
Cube20S
2 Pages
-
Cube
8 Pages
-
Connector-News
2 Pages
-
Comlight57
2 Pages
-
Cable Entry Systems
2 Pages
-
Brandlabel
6 Pages
-
AS-Interface Product news
2 Pages
-
Active Brake Recitifiers
2 Pages
-
48VDC Power Management
2 Pages
-
Insights
32 Pages
-
Impact20
2 Pages
-
Ground Straps
2 Pages
-
FLANGE CONNECTORS
2 Pages
-
Exact12 Safety
2 Pages
-
MIRO BT
6 Pages
-
MICO-Family
12 Pages
-
Interfaces: Service and Field
23 Pages
-
Insight
32 Pages
-
Hybrid Fieldbus Coupling
6 Pages
-
Customized Sets
8 Pages
-
Cube67 and Cube20
44 Pages
-
Connectors for Food and Beverage
16 Pages
-
Bulk Cable by Murrelektronik
44 Pages
-
Automotive Industry
8 Pages
-
AS Interface
24 Pages
-
MVK Metall Safety
8 Pages
-
Passive Connector Solutions
12 Pages
-
Transformers
12 Pages
-
Modlight30-50-70 Signal Towers
12 Pages