S SERIES HOIST PUMPS to control small dump body cylinders
4Pages

HOIST PUMPS to control small dump body cylinders REMOTE MOUNT DIRECT MOUNT • Two integral valve versions available, specify for use with single or double acting hoist • Speeds to 2500 RPM • Pressures to 3000 PSI (207 BAR) • Lever Shift (Detent or spring return) • Optional Air Shift, Cable Shift • Pump capacities: 6, 11, 15 GPM (23, 42, 57 LPM) @ 1000 RPM, 2000 PSI (138 BAR) • Pumps can be used with recommended separate return line (Specify with sleeve for this system that allows the use of a return line filter) • Heavy duty roller bearings • Cast iron construction – fully rebuildable • One year warranty • Lower work port relief standard Note: Intermittent duty cycles only. Not recommended for constant/ continuous applications. Muncie Power Products, Inc.

MUNCIE (S SERIES) HOIST PUMPS MODEL NUMBER CONSTRUCTION S 2 L D —6 —1 R P R B —10 Pump Series Hoists/Porting Single Acting, No Sleeve Single Acting, With Sleeve Double Acting, No Sleeve Double Acting, With Sleeve Port Relief 10 — 1000 PSI (69 BAR) (D.A. Only) Lever Shift Rotation B— Bi-Rotation L — Counter Clockwise R— Clockwise Detent Spring Return Port Location R— Rear Port Type P — Pipe Thread Type of Mounting B— SAE “B” – 4-Bolt R— Remote * Not available on double acting version. RAISE NEUTRAL LOWER MOUNTING DIMENSION SINGLE ACTING 3.35 (85.1) .319 (8.10) .312 (7.92) DIA. PINEYE BOTH...

MOUNTING DIMENSION DOUBLE ACTING INCHES (MM) 1.59 (40.4) 1.09 (27.7) RAISE NEUTRAL LOWER 1/2" - 13UNC - 28 THD. x 1.00 (25.4) DEEP 2 HOLES AS SHOWN RAISE NEUTRAL LOWER 1/2" - 13UNC - 28 THD. x 1.00 (25.4) DEEP 2 HOLES AS SHOWN OVERALL LENGTHS **Requires high pressure relief PS-1231VH for settings above 2500 PSI Notes: DO NOT USE TEFLON TAPE ON PORTS. Optional Air Shift Cylinder (ACM-401). Optional Conversion Sleeve for 3-Line Hookup – Muncie Part No. AA1257. Tank return line must be below oil level at all times. Maximum inlet vacuum is 5 in. hg. (.17 BAR). ++ Units built Nov. 2002 and later...

S - SERIES PUMP WARRANTY THE MUNCIE CAST IRON/ROLLER BEARING PUMP SERIES “S” IS WARRANTED AGAINST ANY DEFECT IN MATERIAL AND WORKMANSHIP WHICH EXISTED AT THE TIME OF SALE BY MUNCIE, ACCORDING TO THE FOLLOWING PROVISIONS, SUBJECT TO THE REQUIREMENTS THAT THE PUMP MUST BE USED ONLY IN ACCORDANCE WITH CATALOGUE AND PACKAGE INSTRUCTIONS, AND THE WARRANTY CARD MUST BE FILLED OUT AND RETURNED TO MUNCIE WITHIN TEN DAYS AFTER THE PUMP IS INSTALLED. THE PUMP IS WARRANTED FOR A PERIOD OF ONE YEAR FROM DATE OF INSTALLATION. IF DURING THE WARRANTY PERIOD THE PUMP FAILS TO OPERATE TO MUNCIE’S...