GEAR PUMPS

Ultimate power and performance in a small package best describes the all new F4 Series gear pumps. The pressure balanced bushing blocks and sleeve bearings provide both extra long life and high performance. Features: • 12 standard sizes • Pressures to 3625 PSI (250 Bar) • Speeds to 3500 RPM • Low noise level • Maximum efficiency • Compact design • Dowel pin design • SAE spline • SAE straight thread O-ring ports • Full one year warranty • 100% break in and test Applications: Designed to meet a multitude of truck mounted equipment including: • Tow and recovery vehicles • snow and ice removal •...

F4 series model number construction p f 4 — 368 — 16 a s B l Pump — P Series — F Design Number Port Location R — Rear Ports* B — Both Side and Rear Ports** (Rear Ports Plugged) Port Type S — ODT St. Thrd. Mounting Flange A — SAE “A” 2-Bolt Q — Thru-Bolt* Notes: Not all pump sizes stocked for SAE “A” mounting flange. For additional information on PTOs for the Ford TorqShift transmission, see FR Series PTO brochure number MP02-09. Shaft Type 16 — 3/4 - 11T Spline * Required for 16Q shaft and flange ** Not Available on Q Flange. Recommended for 16A shaft and flange. F4 series pump specifications...

mounting dimensions IN INCHES (MM) F4 PUMP WITH “Q” FLANGE (Rear ports only) .453 (11) Dia. Thru hole 2 places F4 PuMP WITH “SAE A” FLANGE (Side and rear ports shown) 5.13 (130.2) When required, installer to supply plug Not Shown: -10 ODT Str. Thd. 7/8 - 14UNF (OUTLET) overall lengths * NOTE: The pump input shaft can withstand torques up to the designed shaft torque limitation(STL). This figure is based on multiplying the pump cu. in. displacement times the pump pressure (D x P < STL). Muncie Power Products, Inc.

f4 series pump construction High Tensile extruded aluminum housing Side and Rear Ports available on most models 1-Piece shaft — 12 tooth design Cast Iron front and rear covers 2-Piece bushing block design Dowelled front cover Muncie Power Products, Inc. Buna-N (Nitrile) Shaft Seal

F4 series Gear pump warranty The Muncie “F” Series Gear Pump is warranted against any defect in material and workmanship which existed at the time of sale by Muncie, according to the following provisions, subject to the requirements that the Pump must be used only in accordance with catalogue and package instructions. The Pump is warranted for a period of one year from the date of installation. If during the warranty period the Pump fails to operate to Muncie’s specifications due to a defect in any part in material or workmanship that existed at the time of sale by Muncie, the defective part...