V2
2Pages

data sheet lateral valve type V2 5-V2 valve type with pilot valve 2/2 way valve pressure range orifice connection function externally controlled PN 0-64 bar DN 15 - DN 80 flange valve normally closed symbol NC valve normally open symbol NO design pressure balanced, with spring return body materials ①  ②  ③  ⑤  ④ steel, nickel plated ⑥ stainless steel valve seat synthetic resin on metal / metal on metal seal materials FPM, Graphit Above stated body materials refer to the valve port connections that get in contact with the media only! general specifications special flanges function pressure range details needed for main valve ■ orifice ■ port ■ function NC/NO ■ operating pressure ■ flow rate ■ media ■ media temperature ■ ambient temperature ■ type of actuation Kv value vacuum pressure-vacuum back pressure media details needed for pneumatic actuation ■ nominal voltage ■ type of protection ■ actuation pressure range min/max ■ low wattage coil, actuation pressure range 4-7 bar ■ pilot valve type abrasive media damping flow direction switching cycles switching time media temperature ambient temperature flush ports leak ports limit switches manual override approvals mounting weight additional equipment DN 15 =7,5 | DN 25 =15 | DN 40 =36 | DN 50 = 46 | DN 80 = 200 < 10-4 mbar•l•s-1 pressure side max. 40 bar vacuum side leak rate upon request upon request gaseous version available by throttles on pilot valve as marked upon request 60 to DN 50 100 DN 65-80 400 DN 15-50 direct mounted pilot valve 50 inductive / mechanical electrical specifications nominal voltage power consumption The valves‘ technical design is based on media and application requirements. This can lead to deviations from the general specifications shown on the data sheet with regards to the design, sealing materials and characteristics. protection energized duty rating connection optional additional equipment max. temperature If order or application specifications are incomplete or imprecise there exists a risk of an incorrect technical design of the valve for the required application. As a consequence, the physical and / or chemical properties of the materials or seals used, may not be suitable for the intended application. explosion proof upon request DC 24 V special voltage upon request special voltage upon request AC 230 V 50 Hz 4,8 W 2,5 W pick up 11,0 VA holding 8,5 VA acc. DIN 40050 100% plug acc. DIN EN 175301-803 form B, 4 positions x90° / wire diameter 6-8 mm M12x1 connector acc. DESINA connector acc. VDMA iluminated plug with varistor media 60°C ambient 50°C E Ex e II T5 nominal voltage Un DC 24 V   3,25 W AC 230 V 50 Hz  2,90 W power consumption pneumatic specifications actuation pressure range air consumption cycle speed control pilot valve interface actuator ports 6-10 50 main valve speed variable by throttleson pilot valve preferably 5/2 way pilot valve hydraulic specifications actuation pressure range control actuator ports by media ■ specifications not highlighted are standard specifications highlighted in grey are optional Email info@co-ax.com

function: NC closed when not energized constructive length function: NO open when not energized müller co-ax shall retain the rights to these documents. Modifications to the documents are strictly prohibited. Rights