data sheet coaxial valve type MK 10 2/2 way valve pressure range orifice connection function direct acting PN 0-64 bar DN 10 mm thread valve normally closed symbol NC valve normally open symbol NO design pressure balanced, with spring return body materials ① brass ②  ③ brass, nickel plated ⑤  ④  ⑥ stainless steel valve seat synthetic resin on metal seal materials NBR FPM, CR, EPDM Above stated body materials refer to the valve port connections that get in contact with the media only! general specifications special threads function pressure range details needed ■ orifice ■ port ■ function NC/NO ■ operating pressure ■ flow rate ■ media ■ media temperature ■ ambient temperature ■ nominal voltage Kv value vacuum pressure-vacuum back pressure media abrasive media damping flow direction switching cycles switching time media temperature ambient temperature limit switches manual override approvals mounting weight additional equipment gaseous - liquid - contaminated as marked 200 opening 25 closing 25 DC: -10 to +100 AC: -10 to +100 DC: -10 to +80 AC: -10 to +80 < 10-6 mbar•l•s-1 upon request available (max. 16 bar) bi-directional (max. 16 bar) -30 to +120 -30 to +120 inductive LR/GL/WAZ mounting brackets upon request electrical specifications DC 24 V AC 230 V 40-60 Hz direct-current magnet direct-current magnet with integrated rectifier special voltage upon request special voltage upon request insulating rating protection energized duty rating connection optional additional equipment current consumption nominal voltage actuation The valves‘ technical design is based on media and application requirements. This can lead to deviations from the general specifications shown on the data sheet with regards to the design, sealing materials and characteristics. If order or application specifications are incomplete or imprecise there exists a risk of an incorrect technical design of the valve for the required application. As a consequence, the physical and / or chemical properties of the materials or seals used, may not be suitable for the intended application. N-coil H-coil 100% plug acc. DIN EN 175301-803 form A, 4 positions x90° / wire diameter 6-8 mm connector acc. DESINA iluminated plug with varistor DC 24 V 1,00 A AC 230 V 40-60 Hz 0,13 A explosion proof limit switches terminal box M16x1,5 connector acc. VDMA normally open-PNP normally open-PNP ■ specifications not highlighted are standard specifications highlighted in grey are optional Email [email protected]

function: NC closed when not energized constructive length function: NO open when not energized müller co-ax shall retain the rights to these documents. Modifications to the documents are strictly prohibited. Rights