The Accumeasure board is intended for Original Equipment M anufacturers that require a single channelcapacitance probe amplifier to measure position of grounded targets. The AS-563 can be rack mounted or free mounted using a pig-tail connector and works with MTII standard or custom single ended (single sensor) probes. Best for Applications, Such as. Servo-loop Positioning Control Precision Dimensional Gauging Lens Adj ustment/ Focusing Control Flatness and Profile M easurement Vibration Monitoring Shaft Run-out and Analysis Lobing M easurement Brake Rotor & Spindle Runout Screw Thread Quality Inspection Features • Sub'micron Resolution • Interboard Synchronization * Interchangeable Filter Board 10Hz, 500Hz, 1 kHz, 2kHz and 5kHz available • Built-in Offset Button 'with LED I ndicator • Ai lows the user to shift the gap output voltage over a 10VDC range (Field Calibratable) * Adj ustable Gain Control • Ai lows user to shift the slope sensitivity (Field Calibratable) • Two Connectors Built-in • P2 (50-pin PCB edge connector) • P3 (Molex 50-57-9407) worldwide leader in precision measurement solutions

Standard Specifications The following specifications listed are for the Standard configuration ^ith 1X range. Custom specifications available. [1] Dependent on probe type selected. [2] 100-5kHz. Equivalent to 0.00167% FSR @500Hz RMS. [3] After 100hours site acclimation, warm up, 20°C,100kPa,50% (Temperature, Pressure, Humidity). [4] Signal Proportional to probe gap. [5] Includes connectors which extend beyond the PCB. P3 Wiring Harness * 1 Meter Pig Tail • Power and Analog Out Synchronizatic MTI Instruments, Inc. 325 Washington Avenue Extension Albany, NY 12205-5505 PH: +1-518-218-2550 OR USA...