Ethernet Media Converter Copper to Fiber Optic General Description The TX2FX is an Ethernet media converter that translates transmission signals from a twistedpair 10/100/1000Base-TX cable to a 100BaseFX or 1000Base-X fiber optic cable. It expands network data transmission distances beyond the 100 meter limitation of copper wire to over 10 kilometers by using single-mode fiber optic cable. For the fiber optic port any standard Small Form factor pluggable (SFP) transceiver module can be used on the TX2FX. These SFP transceivers modules are available with a variety of different transmitter and receiver types, allowing users to select the appropriate transceiver for the required fiber optical interface. TX2FX-13 with two copper RJ45 and one SFP port Further the TX2FX provides automatic detection and initializing of the SFP Module and has easyto-read diagnostic LEDs for continuous status reports on network speed, traffic and fiber optic port status. TX2FX Highlights ■ Triple Speed (10/100/1000MBit) Copper Ethernet Interface ■ Automatic detection and initializing of the SFP Module (100MBit-FX or 1000MBit-X over standard SFP Module) ■ Single wide Power Supply input (5 to 36VDC) ■ Different mechanical versions ■ Extended temp. option -40°C to +85°C ■ Configurable Flow Control, Link Loss Forwarding and Link Speed Forwarding ■ Jumbo Frame supported These features make the TX2FX ideally suited for industrial applications. The TX2FX helps to expand your network distances! TX2FX-14 with 2 copper (RJ45 / 2mm header) and SFP If you need a 3D STEP file for the TX2FX, please contact us. Board Key Data Copper Port Fiber Optic Port Status LEDs on RJ45 (10/100/1000Mbit) supports auto crossover, polarity correction over standard SFP transceivers, supports single- and multi-mode, 100Mbit-FX or 1000Mbit-X 2 LEDs for each RJ45 port / 2 LEDs for each SFP port Physical / Power Size (L x W x H) 75.7 x 50.0 x 16.0 mm Power 5VDC to 36VDC Power consumpt. 1.8W 1Gbit copper/optical link Environment Temp. Range Humidity standard -20°C to 60°C, optional -40°C to 85°C 5 - 95% non condensing, optional coating available TX2FX Versions MPL products are 100% designed and manufactured in Switzerland for applications where reliability is key. All products are fanless, shock and vibration proof, low power, rugged, and long-term* available. * Typically 10 years or more, 20+ years repair-ability (after first introduction) TX2FX-11 RJ45 and SFP on same side TX2FX-12 RJ45 and SFP opposite side TX2FX-13 two copper ports RJ45 and one SFP port TX2FX-14 2x copper ports (RJ45 and 2mm header) and one SFP other configurations on request SFP (optical transceiver) in stock SFP-1X 2/1Gbit 850nm, multi mode, up to 500m, -40 to +85°C SFP-2X 1Gbit 1310nm, single mode, up to 10km, -40 to +85°C SFP-3X 100Mbit 1300nm, multi mode, up to 4km, -40 to +85°C or any other standard STP in accordance to MSA &