Pullex Crocodile
2Pages

PULLEX Crocodile Bar puller integrated with the machine’s part-off tool ▪ Fitted together with the part-off tool ▪ Tremendously fast - it clamps the bar instanteneously after cut-off and spindle stop ▪ Flexible design - can be ordered as a ready-to-run unit with toolholder or to fit with an existing toolholder ▪ Compact design - Doesn’t need it’s own turret station - Very narrow - builds out very little - Clamps very close to the chuck jaws ▪ Easy to setup and use You can’t possibility get the work done faster than using this revolutionary Bar Puller. Pullex feeds the bar within 1.5-2 seconds to be compared with the job of a conventional Shortbar Feeder, which would take 10-15 seconds to execute the same operation. Then, assuming a machining cycle time of 50 seconds for your workipiece and you’ll find that: - you are going to save one day each week using Pullex - this is a most profitable accessory for your CNC-lathe After cut-off, the Spindle is stopped Pullex advances a little behind the bar centre for gripping the bar The chuck jaws are unclamped and the bar is pulled out into the new

Own tool holder - Shank type Own tool holder - Blade type Order Code A typical Pullex Crocodile system consist of 1 x Frame 1 x Fixing Plate 1 x set of Pulling Plates Order Code PFD-1 * Iscar tool holders above are prepared for easily being connected to Pullex. Sandvik and other tool holders must be prepared with M6 holes for being connected to Pullex. A typical Pullex Crocodile system consist of 1 x Frame 1 x Fixing Plate 1 x set of Pulling Plates Distributed by: MPC Automation Systems AB IVlrX* Box 5879, S-102 40 Stockholm, Sweden Phone: +46 8 6670950 Fax +46 8 6670952 Visit us at...