Product Segments • Care Motion TiMOTION’s TA23 series is a compact linear actuator primarily used for medical applications that require high force and high speed. This linear actuator also has the ability to save installation space by mounting the control box to the actuator. The TA23 linear actuator is available with an optional IP54 or 66 rating and Hall or Reed sensors for position feedback. General Features Voltage of motor Maximum load Maximum load Maximum speed at no load Maximum speed at full load Minimum installation dimension stroke+171mm An economical solution with compact installation dimens

CODE Rated Load PUSH PULL Self Locking N (PUSH) Typical Current at Rated Load (A) Typical Speed Rated Load (24V DC) mm/s Note 1 The left diagram shows the speed and current figures under pushing condition. 2 Speed would be the same if with 12V motor, but with double current consumption comparing 24V motor. 3 The self locking force above need to work with TiMOTION control system. Terms of Use The user is responsible for determining the suitability of TiMOTION products for a specific application. Due to continuous development in order to improve our products, TiMOTION products are subject to...

Additional retracted length TA Series Safety Additional Stroke Limit Stroke Additional Invalid Length (mm) Note 1 Above stroke recommendation is based on safety stroke limit, for each additional 50mm stroke, it needs to add 5mm for the retracted length. For example 1 If TA23's stroke is 201mm, the retracted length = 201mm+invalid length+5mm. 2 If TA23's stroke is 300mm, the retracted length = 300mm+invalid length+10mm.

Load and Speed See appendix Stroke (mm) Retracted Length Stroke+171mm (for front attachment 1,2,5,6) Stroke+188mm (for front attachment 3,4,B,C) Stroke+183mm (for front attachment 7, 8) Note : before selecting retracted length, please refer to the additional retracted length chart Rear Attachment 4 = Casting U clevis, slot 8.2 mm, hole 10.2mm 5 = Casting U clevis, slot 8.2 mm, hole 12.2mm Front Attachment 1 = Punched hole on the tube with plastic cover on, width 32mm, hole 10.2mm 2 = Punched hole on the tube with plastic cover on, width 32mm, hole 12.2mm 3 = Plastic attachment, width 30mm, with...