MotoFTP is a PC-based software package that allows users to upload and download robot les to and from the robot controller. The software also allows a user to compare les on the robot via FTP (File Transfer Protocol). > Upload les from robot controller to PC (depending on security level). > Download les from PC to robot controller (depending upon security level and operating mode of controller). Compare uploaded or downloaded les with saved les on PC for content changes. Three levels of security: Anonymous ٖ allows the following to be performed: saving job (.jbi), condition (.cnd) and data (.dat) les. FTP allows the following to be performed: loading and saving job (.jbi), condition (.cnd) and data (.dat) les; also saving system information (.sys) les. NXmaster or Xmaster (controller-dependent) Allows the following to be performed: loading and saving job (.jbi), condition (.cnd) and data (.dat) les; also saving system information (.sys) and paramter (.prm) les. > CONNECTION CONFIGURATION FILE COMPARISON ...with Motoman֒s MotoFTP software to connect your robotic systems, and to upload, download robot data les. > DX100 controller Windows XP NX100 controller 1.4 MHz Pentium Class processor XRC controller > Ethernet board (142402-1) for FTP is required for XRC controller only > MOTOMAN CORPORATE HEADQUARTERS805 LIBERTY LANE, WEST CARROLLTON, OHIO 45449TEL: 937.847.6200 ? FAX: 937.847.6277 TECHNICAL SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE DS-316-A 2009 MOTOMAN INC. MAY 2009MOTOMAN IS A REGISTERED TRADEMARKWINDOWS IS A REGISTERED TRADEMARK OF MICROSOFTALL OTHER MARKS ARE THE TRADEMARKS OR REGISTERED TRADEMARKS OF MOTOMAN INC. size="-4">