BD62
7Pages

Product Data Sheet BD62 belongs to the design concept of slider-type linear motion, which can obtain a larger stroke with a smaller installation size, and can be applied in both push and pull directions. The compact size design is an ideal driving solution in the fields of furniture, home care and fitness equipment. MOTECK www.moteck.com Main applications: Furniture, Home care and Fitness equipment Standard features: • Input voltage: 24V DC • Max. load: 3000N (Push / Pull) • Max. speed at no load: 6.2mm/sec (typical value) • Speed at full load: 3.8mm/sec (typical value @3000N Loaded) • Stroke: 100 ~ 1000mm • Noise level: ^55dB • IP Level: IP20 • Preset limit switches • Front end cover has the metal plate for fixing • Duty cycle: 10%, max. 2 min. continuous operation in 20 min. • Operating ambient temperature: -20°C ~ +65°C Options: • Positioning signal feedback with Hall effect sensor x 2

Remarks: * The typical speed or typical current means the average value neither upper limit nor lower limit. The performance curves are made with typical values.

• Available stroke (S) range = 100 ~ 1000mm • Extended length (B) = Retracted length (A) + Stroke (S) • Retracted length (A) = 142mm Min. (±3mm) • Drawing • Front connector D: D-type plastic silder block • Rear connector 0: Plastic

Remarks: * Connect Direct-Cut cable to DC power supply and hand control directly, no control box.

Cable Plug A. With Moetck F-type or L3-type plug (Required to be connected to the control box): ● Without positioning feedback M- ● Positioning feedback with dual Hall effect sensors GND Note: Pin definition Definition Power Connect M+ to “Vdc +” & M- to “Vdc -“ of DC power to extend the actuator. Switch the polarity of DC input to retract it. Voltage input range (Vin): 3.5 ~ 20V Hall effect sensor resolution: 6.667 pulses/mm Output voltage of signal (DATA) = Vin Hall signal data: Vin Actuator extends

B. With Direct-Cut cable DL1 or TL1 (NOT required to be connected to any control box): ● Hand control connector: with Moteck U-type female connector - 1 drive - 2 drives M1- 5-pin connector (Moteck pinout: C-DIN-51R) 5-pin connector (Moteck pinout: C-DIN-52R) Note: Connect M+ to “Vdc +” & M- to “Vdc -“ of DC power to extend the actuator. Switch the polarity of DC input to retract it. Definition of the M2 actuator is the same. ● Power plug: with Moteck S-type DIN 41529 male plug ● Connector for 2nd actuator: with Moteck R-type DIN 41529 female connector (for TL1 only) ● Cable length - With...

Ordering Key BD62 - D 0 - 24 Front connector Rear connector D: D-type plastic slider block (Refer to Page 3) Input voltage Motor and spindle type Retracted length Extended length Positioning feedback 0: None H: Dual hall effect sensors Location of cable outlet 0: 300mm straight 1: 1000mm straight 2: 450mm with 300mm coiled A: Dedicated cable DL1, without control box (Refer to Page 6) B: Dedicated cable TL1, without control box (Refer to Page 6) Terms of Use The user is responsible for application suitability of Moteck products. As ongoing improvement process continues, products listed on...