The Specialist In Drum Handling Equipment Mix Inside Closed Shipping Cans Efficient “corner-over-corner” tumbling action Use separate can for each batch Use common 1 to 5 gallon pails for mixing No container to purge between batches Model 2-305-1 shown Single Can Tumblers rotate one can “corner-over-corner” Rotate your cans or pails to thoroughly blend ingredients with an efficient “corner-over-corner” mixing action. Morse Can Tumblers are perfect to mix or blend small batches... or you can tumble parts with media to polish or deburr. Mixing in ordinary pails, instead of using special containers or insertion mixers, saves time and money! There is no costly transfer and no messy clean-up. It reduces the possibility of spills and the hazards of worker exposure to the product. Double Can Tumblers rotate one or two cans at a time Enclosures with Safety Interlock The cans are held at an angle to the horizontal rotating shaft to provide a thorough “corner-over-corner” mixing action. Quickly secure a can in the holder with the adjustable bottom cross bar and screw-down top bar with locking handle. A 1/4 HP motor provides plenty of power for long service. It rotates the pail at a constant 23 RPM (19 RPM on 50Hz models) in one direction – the unit does not shake or oscillate cans. The heavy-duty steel frame stands steady while tumbling. Handles Can: Rotation Speed: 23 RPM on 60Hz models Explosion proof available Air powered models available Guard Enclosure shown installed with Double Can Tumbler (Can Tumbler sold separately). Single phase, 115V models (models 1-305-1 and 2-305-1) are equipped with an adjustable timer. This allows the operator to select a running time up to 60 minutes with automatic shut-off. Other motor types do not include timer, cord or plug, and must be wired according to your local codes by a qualified electrician. Install all Morse Can Tumblers and drum rotators in accordance with OSHA requirements for enclosure with interlock, etc. For OSHA compliance, see OSHA subpart O.1910.212(a)(4) “Barrels, containers, and drums. Revolving drums, barrels, and containers shall be guarded by an enclosure which is interlocked with the drive mechanism, so that the barrel, drum, or container cannot revolve unless the guard enclosure is in place.” Power connections and motor controls must comply with applicable codes.

The Specialist In Drum Handling Equipment Can Tumbler Model Numbers Model # Full Load Amp Draw TEFC with 1 to 60 minute timer Explosion proof * Explosion proof * Explosion proof * Explosion proof * Explosion proof * TEFC with 1 to 60 minute timer Explosion proof * Explosion proof * Explosion proof * Explosion proof * Explosion proof * * Explosion proof motors are rated for class I group D and class II groups F and G. ** Air powered models require plant air at 40 psi and flowing at a rate of 22 scfm. Filter, Regulator, Lubricator and valve (Morse Kit # 90010-P) should be installed in the air line...

The Specialist In Drum Handling Equipment Options to Mix Larger Cans Options to Mix Larger Cans Accommodate a can: • Up to 16” (40.6 cm) diameter • 11” to 22” (28 to 55.9 cm) tall • Capacity: 100 Lb. (45.5 kg) per can These options include raised base and larger can holder(s). Single Can Tumbler shown with option to mix a larger can installed. Double Can Tumbler shown with option to mix two larger cans installed. Option XLC-1-305 includes • 1 Extra-Large Can Holder • 2 Risers for Can Tumbler base Option XLC-2-305 includes • 2 Extra-Large Can Holders • 2 Risers for Can Tumbler base IMPORTANT NOTE:...