TFxxxxGN
1 /3Pages

Catalog excerpts

Signal conditioning modulesTFxxxxGN Series Active high precision output signal conditioning module FEATURES • Two- port isolation (signal input and signal output) • High accuracy (0.1% F.S.) • High linearity (0.1% F.S.) • Isolation voltage (2kVAC/60s) • Low ripple & noise: (^35mVpp, 20MHz) • Extremely low temperature coefficient (^50PPM/°C) • Compact size, standard DIP8 package • EN60950 approval The TFxxxxGN series is with unipolarity signal input and backward bipo/arty signal output, and with an inner high efficiency isolated micro-power source, it can provide isolation power to peripheral circuit at the same time of providing power to internal signal processing circuit. Adopting electromagnetism isolation technology, therefore compared with phofo-coup/er isolation, it has higher accuracy and lower temperature coefficient. This module is two-port isolation (Input and output). MORNSUN GUANGZHOU SCIGNCG & TECHNOLOGY CO.,LTD. MORNSUN Guangzhou Science & Technology Co., Ltd. reserves the copyright and right of final interpretation

Open the catalog to page 1

Signal conditioning modulesTFxxxxGN Series General Specifications 1. Please read the instructions carefully before use; contact our technical support if you have any problem; 2. Do not use the product in hazardous areas; 3. Use DC power supply for the product and 220V AC power supply is prohibited; 4. Do not dismount and assemble the product without permission to avoid failure or malfunction of equipment; 5. Unless otherwise specified, parameters in this datasheet were measured under the conditions of Ta=25°C, humidity<75% with power input nominal voltage and rated signal output full load. After-sales...

Open the catalog to page 2

Signal conditioning modules TFxxxxGN Series 2. Wiring diagram for product application Pin- Power input Signal output Pout+ PGND Isolation Power output Signal input Notes: 1.When used, the signal negative output is required to be short with isolation power GND , that is, 2 feet and 17 feet short answer. 2.Pins 16, 17 and 18 are NC pins in case of no Isolation power output. 3.NC:no connection(2 feet and 17 feet short too). Recommended parameters 4. For more information please find the application notes on www.mornsun-power.com Dimensions and Recommended Layout Packing Information please refer to...

Open the catalog to page 3