TExxxxAN
1 /3Pages

Catalog excerpts

TExxxxAN Series Signal conditioning modules FEATURES • two-terminal isolation (signal input and output are mutually isolated) • High precision grade (0.1% F.S.) • High linearity (0.1% FS.) • Isolation voltage (2KVAC/60s) • Extremely low temperature drift (50PPM/°c) • Industrial grade (range of operating temperature: -40c to +85c) • High reliability (MTBF >500,000 hours) • Low ripple & noise: «S30mVp-p(20MHz) 0 ESD protection (IEC/EN61000-4-2 Contact ±4KV perf. Criteria B) • Small footprint: DIP Package(26*9.5*12.5mm) • Signal load capacity: ^2K^ (@Max. signal output @10V) TExxxxAN senes is analog signal isolation modules with front-end positive/negative signal input and rear-end positive signal output. They are equipped with built-in effcient micro-power source can supply other power to the internal circuit of input signal. The product adopts the electromagnetic isolating technology as a substitute for the traditional linear opto-isoiator. In contrast, this type ofproduct has a better performance in temperature drift, linearity, low power consumption and Low ripple. They are two -terminal isolation (input of power supply, signal output end signal output are mutually isolated) MORNSUN Guangzhou Science & Technology Co., Ltd. reserves the copyright and right of final interpretation MORNSUN GUANGZHOU SCIENCE & TECHNOLOGY CO..LTD.

Open the catalog to page 1

Signal conditioning modulesTExxxxAN Series General Specifications 1. Please read the instructions carefully before use; contact our technical support if you have any problem. 2. Do not use the product in hazardous areas. 3. Use DC power supply for the product and 220VAC power supply is prohibited. 4. Do not dismount and assemble the product without permission to avoid failure or malfunction of equipment. After-sales service 1. Ex-factory inspection and quality control have been strictly conducted for the product; if there occurs abnormal operation or possibility of failure of internal module,...

Open the catalog to page 2

Signal conditioning modulesTExxxxAN Series2. Recommended EMC circuit TE5530AN 3. For more information please find the application notes on www.mornsun-power.comDimensions and Recommended Layout THIRD ANGLE PROJECTION Front View Pin-Out Signal input(+) Signal input(-) Bottom View Signal output(-) Signal output!*) Power supply!*) Unit :mm[inch] NC:No connection Notes: 1. Packing Information please refer to 'Product Packing Information'. Packing bag number: 58240002; 2. Unless otherwise specified, data in this datasheet should be tested under the conditions of Ta=25°C, humidity<75% when inputting nominal...

Open the catalog to page 3