TEMxxxxCN
1 /4Pages

Catalog excerpts

Signal conditioning modulesTEMxxxxCN Series TEMxxxxCN series is analog signal isolation modules with f millivolt-class positive/negative voltage signal input and rear-end positive/negative voltage signal output. They are equipped with built-in efficient micro-power source and can supplying power to the internal circuit of the product. The product adopts the electromagnetic isolating technology as a substitute for the traditional linear opfo-iso/afor. In contrast, this type of product has a better performance in temperature drift, linearity, low power consumption and Low ripple. They are two -terminal isolation (input of power supply, signal output and signal output are mutually isolated) Signal conditioning modules Package — Isolation power output — Power supply — Signal output — Signal input — Input signal type — Isolation amplifier analog signal isolation modules with FEATURES • Two- port isolation (signal input and output are mutually isolated) • High precision (0.1% F.S.) • High linearity (0.1% F.S.) • Isolation voltage (2KVAC/60s) • Extremely low temperature coefficient (50PPM/°C, within -40 to +85C) • Industrial grade (operating temperature range: -40C to +85C) • High reliability (MTBF >500,000 hours) • Low ripple & noise: ^35mVp-p(20MHz) • ESD protection (IEC/EN61000-4-2 Contact ±4KV perf. Criteria B) • Compact size: DIP Package(26*9.5*12.5mm) • With load capacity: 2s2K 0 @10V Input Specifications Output Specifications Item Transmission Specifications MORNSUN GUANGZHOU SCIENCE & TGCHNOLOGY CO.,LTD. MORNSUN Guangzhou Science & Technology Co., Ltd. reserves the copyright and right of final interpretation

Open the catalog to page 1

Signal conditioning modulesTEMxxxxCN Series Temperature Coefficient 1. Please read the instructions carefully before use; contact our technical directly if you have any problem. 2. Do not use the product in hazardous areas. 3. Use DC power supply for the product and 220V AC power supply is prohibited. 4. Do not dismantle and assemble the product without permission to avoid failure or malfunction of equipment. 5. Unless otherwise specified, parameters in this datasheet were measured under the conditions of Ta=25 °C, humidity<75% with power input nominal voltage and rated signal output full load. After-sales...

Open the catalog to page 2

Signal conditioning modules TEMxxxxCN Series 2. Typical application circuit Typical application circuit one: Positive and negative power supply current signal detection scheme The signal conditioning module TEMxxxxCN series, in the dual power supply conditions (VCC, VEE), can be used to detect any direction’s current values . As shown in the Fig. 1, if the current detection resistor series to the current loop, then the loop current will generate mV level voltage signal in the resistance, the signal conditioning modules, complete signal amplification, and feedback to the back-end instrument. The...

Open the catalog to page 3

3. Recommended EMC circuit MORNSUN® 4. For more information please find the application notes on www.mornsun-power.com Dimensions and Recommended Layout THIRD ANGLE t»ROJECT>ONW^ H 1.75±0.5 [0.069±0.020] -I Note: Unit :mm[inch] Pin section tolerances :±0.10[±0.004] General tolerances:±0.25[±0.010] Note: The part of the signal input connection mode for product will be different according to the signal circuit, please refer to the wiring diagram for product application and typical applications. Notes: 1. Packing information please refer to Product Packing Information which can be downloaded from...

Open the catalog to page 4