TEMxxxxAN
1 /4Pages

Catalog excerpts

Signal conditioning modulesTEMxxxxAN SeriesSignal conditioning modules RoHS PART NUMBER SYSTEM EMxxxxAN Package Isolation power output Power supply Signal output Signal input Input signal type Isolation amplifier FEATURES • Two- port isolation (signal input and output are mutually isolated) • High precision (0.1% F.S.) • High linearity (0.1% F.S.) • Isolation voltage (2KVAC/60s) • Extremely low temperature coefficient (50PPM/C) • Industrial grade (operating temperature range: -40c to +85c) • High reliability (MTBF >500,000 hours) • Low ripple & noise: ^30mVp-p(20MHz) • ESD protection (IEC/EN61000-4-2 Contact ±4KV perf. Criteria B) • Compact size: DIP Package(26*9.5*12.5mm) • With load capacity: ^2KQ(@Max. signal output @10V) TEMxxxxAN series is analog signal isolation modules with front-end mV-level positive/negative signal input and rear-end positive signal output They are equipped with built-in efficient micro-power source can supply other power to the internal circuit of input signal. The product adopts the electromagnetic isolating technology as a substitute for the traditional linear opto-isoiator. In contrast, this type of product has a better performance in temperature drift, linearity, low power consumption and Low ripple. They are two -terminal isolation (Input of power supply, signal output and signal output are mutually isolated) MORNSUN GUANGZHOU SCIENCE & TECHNOLOGY CO.,LTD. MORNSUN Guangzhou Science & Technology Co., Ltd. reserves the copyright and right of final interpretatio

Open the catalog to page 1

Signal conditioning modulesTEMxxxxAN Series General Specifications 1. Please read the instructions carefully before use; contact our technical support if you have any problem; 2. Do not use the product in hazardous areas; 3. Use DC power supply for the product and 220VAC power supply is prohibited; 4. Do not dismount and assemble the product without permission to avoid failure or malfunction of equipment; 5. Unless otherwise specified, parameters in this datasheet were measured under the conditions of Ta=25 °C, humidity<75% with power input nominal voltage and rated signal output full load. After-sales...

Open the catalog to page 2

Signal conditioning modules TEMxxxxAN Series 2. Typical application circuit Typical application circuit one: Positive and negative power supply current signal detection scheme The signal conditioning module TEMxxxxAN series, in the dual power supply conditions (VCC, VEE), can be used to detect any direction’s current values . As shown in the Fig. 1, if the current detection resistor series to the current loop, then the loop current will generate mV level voltage signal in the resistance, the signal conditioning modules, complete signal amplification, and feedback to the back-end instrument. The...

Open the catalog to page 3

THIRD ANGLE PROJECTION-(®Hffl 01.00 [00.039] Note: Unit :mm[inch] Pin section tolerances :±0.10[±0.004] General tolerances:±0.25[±0.010] Note: The part of the signal input connection mode for product will be different according to the signal circuit, please refer to the wiring diagram for product application and typical applications. 1. Packing Information please refer to 'Product Packing Information'. Packing bag number: 58240002; 2. All index testing methods in this datasheet are based on our Company's corporate standards; 3. The performance indexes of the product models listed in this datasheet...

Open the catalog to page 4