TAxxxW-xx
1 /4Pages

Catalog excerpts

TAxxxW-xx series 12.5mm analog signal isolators / Transducers power supply FEATURES • Three-port isolation (input, output and power supply) • 12.5mm slim case • High accuracy (0.1% FS.) • High linearity (0.1% FS.) • Low temperature drift(35PPM/°C) • Low-power dissipation • EMI meets CISPR22/EN55022 • EMS meets IEC/EN61000 • High reliability(MTBF>500,000 hours) The current or voltage signal from application Held is picked up by this product and transmitted to the control cabinet. One independent power supply is required. Moreover, within the interface of'rail power supply, input and output are mutually isolated. A green LED indicates that the device is working. Field devices connected with this product:2-wire or 3-wire isolation transducer (Distributor), industrial standard current source (not to be used in intrinsically safe area). MORNSUN GUANGZHOU SCIENCC & TECHNOLOGY CO.,LTD. MORNSUN Guangzhou Science & Technology Co., Ltd. reserves the copyright and right of final interpretation

Open the catalog to page 1

TAxxxW-xx series Output Specifications Transmission Specifications General Specifications Physical Specifications Application Precautions 1. Please read the instructions carefully before use; contact our technical support if you have any problem; 2. Do not use the product in hazardous areas; 3. Use DC power supply for the product. and 220V AC power supply is prohibited; 4. Do not disassemble or assemble the product without permission to avoid explosion protection failure or malfunction of product. MORNSUN® 2015.04.08-B/0 Page 2 of 4 MORNSUN Guangzhou Science & Technology Co., Ltd. reserves...

Open the catalog to page 2

TAxxxW-xx series Design Reference Note: When use bottom power supply, anyone group or both is OK. Bottom power supply port 1) The instrument wiring using direct plug wiring terminal, easy touse; 2) Recommended the sectional area of conductor is 0.5mm2-2.5 mm2; 3) Recommended the length of conductor exposed is 8mm and is fastened by M3 bolts. In the field application, isolator should not be installed In intrinsically safe area. 3. Selection guidelines for Isolator or Isolator with isolation power output 1) Take care of output independence of isolator or isolator with isolation power output and...

Open the catalog to page 3

TAxxxW-xx series Installation & disassembly Installation DIN35mm standard rail installation 1. Insert the top of the instrument card in the rail; 2. Push the bottom of the instrument into the rail Disassembly 1. Insert to the clamp on the lower end of instrument with a screw driver (tool edge width ^6mm); 2. Push the screw driver up, and pry the clamp down; 3. Pull the instrument up out of the guide rail. THIRD ANGLE PROJECTIOI Note: Unit:mm[inch] General tolerances:±0.50[±0.002] Wire range:28~12 AWG PWR Power Indicator Note: 1. Packing Information please refer to 'Product Packing Information'....

Open the catalog to page 4