TAF1xxW-EX-xx
1 /4Pages

Catalog excerpts

Ultra-thin analog signal output isolation safety barrier PART NUMBER SYSTEM TA FxxxW-EX-xx FEATURES • Input, output and power supply are mutually isolated from each other • High accuracy (0.1% FS.) • Low ripple & noise • Isolation voltage between Hazardous zone and safe zone: 2000VAC • Low temperature coefficient (50PPM/°C) • Excellent EMC performance (without external circuit :EN61326 standards) • High reliability(MTBF>500,000 hours) • HART Communication protocol • With the base power supply Ultra-thin analog signal output isolation safety barrier receives the current (voltage) signals from safe zone and transmits the standard current signals to the hazardous zone isolated by linear processing, at the same time restricts the energy leakng form the port to the hazardous zone, which ensures the explosion protection capability of the system, The HART communication function enables the products to achieved HART signal half duplex communication in 25CQ load. The series products need independent power supplies, and the signa input, signal output and the power supplies are isolated from each other. The product's shell is as thin as !2,5mm. Site equipments connected: Two-wire valve localizer, electrical converter etc,; Application Zones: zone 0 zone 1, zone 2, HA, iiB, IIC and T4~T6. industries applications: intrinsically safe explosion protection systems of chemical engineering, petroleum, metallurgy, mining, pharmacy, natural gas, electric power, etc, Selection Guide Input Specifications Output Specifications MORNSUN A MORNSUN GUANGZHOU SCIENCC & TECHNOLOGY CO.,LTD. MORNSUN Guangzhou Science & Technology Co., Ltd. reserves the copyright and right of final interpretation

Open the catalog to page 1

General Specifications & Explosion Protection Certification parameter Physical Specifications Application Precautions 1. Please read the instructions carefully before use; contact our technical directly if you have any problem; 2. Do not use the product in hazardous zones; 3. Use DC power supply for the product, and 220V AC power supply is prohibited; 4. Do not disassemble or assemble the product without permission to avoid explosion protection failure or malfunction of product. MORNSUN A MORNSUN GUANGZHOU SCIENCC & TECHNOLOGY CO.,LTD. MORNSUN Guangzhou Science & Technology Co., Ltd. reserves...

Open the catalog to page 2

Design Reference TAF1XXW-EX series input 1 output 2. Application of surge protector Use conductors to connect the grounding wire or casing of equipment protected with the grounding wire of surge protector directly and shorten the connecting wire as short as possible. Ground with a single point at the grounding port of surge protector. Thus, high voltage generated between the surge protector and grounding wire of equipment protected is avoided, so that it plays an effective role in protection. 3. Application in the intrinsically safe explosion protection system In the intrinsically safe explosion...

Open the catalog to page 3

Installation & disassembly Installation DIN12.5mm standard rail installation 1. Insert the top of the instrument card in the rail; 2. Push the bottom of the instrument into the rail. 1. Insert to the clamp on the lower end of instrument with a screw driver (tool edge width ^6mm); 2. Push the screw driver up, and pry the clamp down; 3. Pull the instrument up out of the guide rail. THIRD ANGLE PROJECTION 1. Packing information please refer to Product Packing Information which can be downloaded from www.mornsun-power.com. Packing bag number: 58040010; 2. Unless otherwise specified, parameters in...

Open the catalog to page 4