*mydirectindustry

MCP100
1 /4Pages

Catalog excerpts

MCP100 Series100W, 165~265VAC Input, AC/DC capacitor charging module power supply RoHS FEATURES • With charging function, the output ultra-capacitor can be charged • Industrial grade operating temperature: -40C to 75C • High isolation voltage: 3000VAC • Output Voltage continuously adjustable • Chassis mounting • MTBF>100,000 H MCPi00—i00W converter offered by Mornsun. It features high reliability and high isolation voltage., continuously adjustable output voltage., They are widely used in power permanent-magnet switch controller. Electricity network cabinet and other electrical equipment. They can be used as uninterruptible power supply with ultra capacitor. Selection Guide Input Specifications Output Specifications Item Note: *When the voltage on Voc is between 0V and the rated output voltage (24~28V adjustable),the Voc works in constant current mode, and it was constant voltage mode after the voltage reaches the rated output voltage; **Ripple and noise tested with "parallel cable" method, please see AC-DC Converter Application Notesfor specific operation methods. General Specifications MORNSUN GUANGZHOU SCIENCE & TECHNOLOGY CO.,LTD. MORNSUN Guangzhou Science & Technology Co., Ltd. reserves the copyright and right of final interpretation

Open the catalog to page 1

AC/DC ConverterMCP100 Series Physical Specifications Temperature Derating Graph Input Voltage (VAC) Note: This product is suitable for use in natural air cooling environments, if in a closed environment, please contact our company's FAE. MORN5UN GUANGZHOU SCIENCE & TECHNOLOGY CO.,LTD. MORNSUN Guangzhou Science & Technology Co., Ltd. reserves the copyright and right of final interpretation

Open the catalog to page 2

AC/DC Converter MCP100 Series Design Reference 1. Application specification (1) The K terminal is a warning terminal. When the AC input is normal, The K terminal is a high level to -Vo1, which is greater than 23V. When the AC input fails, The K terminal is a low level to -Vo1, which is less than 5V. The K terminal can not be used as a load output terminal. (2)To avoid any danger, the output super capacitance can not reverse. (3) Before connecting the capacitor to the power supply, need to make sure the capacitor is not pre-charged in case of damaging the power supply, If the circuit is well connected...

Open the catalog to page 3

AC/DC ConverterMCP100 Series Note: 1. Packing Information please refer to 'Product Packing Information'. Packing bag number: 58020022; 2. Unless otherwise specified, data in this datasheet should be tested under the conditions of Ta=25°C, humidity<75% when inputting nominal voltage and outputting rated load; 3. All index testing methods in this datasheet are based on our Company's corporate standards; 4. The performance indexes of the product models listed in this manual are as above, but some indexes of non-standard model products will exceed the above-mentioned requirements, and please directly...

Open the catalog to page 4