IB_S-2W / 2watt DC-DC converter
1 /3Pages

Catalog excerpts

FEATURES Small Footprint SIP Package 1KVDC Isolation Temperature Range: -40°C to +85°C No Heat sink Required Internal SMD Construction Industry Standard Pinout No External Component Required RoHS Compliance IB_S-2W Series 2W, FIXED INPUT, ISOLATED & REGULATED SINGLE OUTPUT DC-DC CONVERTER Patent Protection RoHS The IB_S-2W Series are specially designed for applications where a group of polar power supplies are isolated from the input power supply in a distributed power supply system on a circuit board. These products apply to: 1) Where the voltage of the input power supply is fixed (voltage variation ≤±5%); 2) Where isolation is necessary between input and output (isolation voltage ≤1000VDC); 3) Where the regulation of the output voltage and the output ripple noise are demanded. MODEL SELECTION IB0505S-2W Rated Power Package Style Output Voltage Input Voltage Product Series PRODUCT PROGRAM Input Voltage (VDC) Input Current (mA)(Typ.) OUTPUT SPECIFICATIONS Item Test condition Line regulation Load regulation Output voltage accuracy Temperature drift Output ripple* Output Noise* *Test ripple and noise by “parallel cable” method. See detailed operation instructions at DC-DC Application Notes. COMMON SPECIFICATION Item Test Conditions Storage humidity range Operating temperature Storage temperature Lead temperature Temp. rise at full load 1.5mm from case for 10 seconds Case material The copyright and authority for the interpretation of the products are reserved by MORNSUN

Open the catalog to page 1

The copyright and authority for the interpretation of the products are reserved by MORNSUN IB S-2W 2014.08.21-B/1 Page 2 of

Open the catalog to page 2

APPLICATION NOTE 1)Requirement on output load To ensure this module can operate efficiently and reliably, During operation, the minimum output load could not be less than 10% of the full load. If the actual output power is very small, please connect a resistor with proper resistance at the output end in parallel to increase the load. 2)Recommended circuit If you want to further decrease the input/output ripple, an “LC” filtering network may be connected to the input and output ends of the DC/DC converter, see (Figure 1). L (Figure 1) It should also be noted that the inductance and the frequency...

Open the catalog to page 3