DC/DC Converter F_XT-2WR2 Series 2W, Fixed input voltage, isolated & unregulated single output Operating temperature range: -40℃ to +105℃ High efficiency up to 84% Miniature SMD package Isolation voltage: 3K VDC No external component required International standard pin-out Patent Protection RoHS F_XT-2WR2 series are specially designed for applications where an isolated voltage is required in a distributed power supply system. They are suitable for 1. Where the voltage of the input power supply is stable (voltage variation: ±10%Vin); 2. Where isolation between input and output is necessary (isolation voltage ≤3000VDC); 3. Where the output voltage regulation and the ripple & noise of the output voltage is not strictly required; 4. Typical application: preceding-stage interference isolation condition; ground-interference canceled condition; digit circuit condition; Voltage-isolation converting condition; normal low-frequency artificial circuit condition; relay drive circuit condition, etc. Selection Guide Input Voltage (VDC) Certification Efficiency (%,Min./Typ.) Output Voltage Output Current (mA)(Max./Min.) @ Full Load Input Specifications Item Operating Conditions Input Current (full load / no-load) Reflected Ripple Current Input Filter Hot Plug Filter capacitor Unavailable MORNSUN Guangzhou Science & Technology Co., Ltd. reserves the copyright and right of final interpret

DC/DC Converter F_XT-2WR2 Series Output Specifications Item Operating Conditions Output Voltage Accuracy Line Regulation Input voltage change: ±1% Load Regulation See tolerance envelope curve(Fig. 1) Ripple & Noise* Temperature Coefficient Full load Short Circuit Protection** Note: *Ripple and noise are measured by “parallel cable” method, please see DC-DC Converter Application Notes for specific operation; ** supply voltage must be discontinued at the end of short circuit duration. General Specifications Item Operating Conditions Isolation Voltage Input-output, with the test time of 1 minute...

DC/DC Converter F_XT-2WR2 Series Temperature Derating Cur ve Output P ower Percent(%) Output Voltage Accuracy (%) Product Characteristic Curve Output Cur rent Perc ent(%) (Nominal Input Voltage) Efficiency Vs Input Voltage (Full Load) 90 Input Voltage(V) Efficiency Vs Input Voltage (Full Load) 90 F1212XT-2WR2 Output Current Percentage(%) Output Current Percentage(%) Input Voltage(V) Design Reference 1. Typical application circuit If it is required to further reduce input and output ripple, a filter capacitor may be connected to the input and output terminals, see Fig.3. Moreover, choosing a suitable...

DC/DC Converter F_XT-2WR2 Series 2. EMC solution-recommended circuit Input voltage (VDC) C1 C2 EMI C3 CY LDM Note: 1. 24V input series, 24V output series is subject to CY (CY : 1nF/3KV). 2. It is not needed to add the component in the peripheral circuit when parameter with the symbol of "--". 3. Output load requirements When using, the minimum load of the module output should not be less than 10% of the nominal load. In order to meet the performance parameters of this datasheet, please connect a 10% dummy load in parallel at the output end, the dummy load is generally a resistor, Please note...

DC/DC Converter F_XT-2WR2 Series Packing information please refer to Product Packing Information which can be downloaded from www.mornsun-power.com. Packing bag number: 58210024; If the product is not operated within the required load range, the product performance cannot be guaranteed to comply with all parameters in the datasheet; The maximum capacitive load offered were tested at nominal input voltage and full load; Unless otherwise specified, parameters in this datasheet were measured under the conditions of Ta=25℃, humidity<75% with nominal input voltage and rated output load; All index...