Catalogs >
MORNSUN Guangzhou Science & Technology Co.,Ltd. >
CF0505XT-1WR2

CF0505XT-1WR2
4Pages

Catalog excerpts

DC/DC ConverterCF0505XT-1WR2 1W, Fixed input voltage, isolated & unregulated single outputPatent Protection RoHS FEATURES • Short circuit protection (self-recovery) • Operating temperature range: -50C to +125°C • Isolation voltage: 3.5K VDC • Compact SMD package • Internal surface mounted design • International standard pin-out • Components meet AEC-Q100 standards • The production process meet TS16949 system requirements The CF0505XT-1WR2 is designed for application where isolated output is required from a distributed power system, it can be used in automobile motor control and drive system. Such as motor vehicle communication system controller, engine control system, the ignition system, the motor voltage monitoring, the electronic accelerator pedal, automobile tire pressure detection system, doors and tail lights controller, air conditioning control and battery management system (BMS), etc. MORN5UN GUANGZHOU SCIGNCG & TGCHNOLOGY CO.,LTD. MORNSUN Guangzhou Science & Technology Co., Ltd. reserves the copyright and right of final interpretation

Open the catalog to page 1

DC/DC ConverterCF0505XT-1WR2 Reflow Soldering Temperature Temperature Derating Graph 120 100 o I 80 | 60 o 40 20 Design Reference 1. Typical application If it is required to further reduce input and output ripple, a filter capacitor can be connected to the input and output terminals, see Fig.3. Moreover, choosing suitable filter capacitor is very important, start-up problems may be caused by too large capacitance. To ensured the modules running well, the recommended capacitive load values as shown in Table 1. The simplest device for output voltage regulation, over-voltage and over-current...

Open the catalog to page 2

DC/DC ConverterCF0505XT-1WR2 Fig.3 Fig.4 Recommended capacitive load value table (Table 1) 2. EMC typical recommended circuit LDM Vin C1 Fig. 5 3. Output load requirements In order to ensure the converter can work reliably with high efficiency, the minimum load should not less than 10% rated load when it is used. If the needed power is indeed small, please parallel a resistor on the output side ( The sum of the efficient power and resistor consumption power is not less than 10%). THIRD ANGLE PROJECTION Front View Right View Unit: mm[inch] NC: Pin to be isolated from circuitry MORNSUN...

Open the catalog to page 3

1. Packing information please refer to Product Packing Information which can be downloaded from www.mornsun-power.com. Packing bag number: 58210024; 2. If the product is not operated within the required load range, the product performance cannot be guaranteed to comply with all parameters in the datasheet; 3. The maximum capacitive load offered were tested at input voltage range and full load; 4. Unless otherwise specified, parameters in this datasheet were measured under the conditions of Ta=25"C, humidity<75%RH with nominal input voltage and rated output load; 5. All index testing methods...

Open the catalog to page 4