S P E C I F I C AT I O N S G E N E R AL Morbark 52” Circular Chop Saw 50 HP TEFC WEG 365 T-frame electric motor @ 1150 RPMs 52” circular slasher saw 2-15/16” mandrel with 8” saw collars 2-15/16” Dodge series “E” flange bearings on mandrel 5 groove 5V sheaves with gripnotch belts 2-15/16” pivot shaft with ANSON 2500 series bearings 310 welded hydraulic cylinder to raise and lower saw Maximum log diameter 20” Note: Specifications may vary with equipment options Log clamp 628 style (log clamp mounts on both sides of trough and pivots down over center of chain) Log clamp (arm style mounts on one side of trough or roll case) 48” saw in lieu of standard 52” 15 HP hydraulic unit to operate saw up and down and includes two log clamps and control valves