CHIP-PACS F E AT URES • Screen mounts above chipper for no wasted space • 5’ x 5’ screen is utilized on 48” Chip-Pac; 6’ x 6’ screen utilized on 58” Chip-Pac • Acceptable chips are able to be discharged on either side of the chip-pac • Flexible rods support the screen-no knuckle joints are used • All screens are factory tested and balanced OPTIONAL EQUIPMENT 3-HP fines blower with 3-HP electric motor mounted on swivel base Hydraulic 10-HP chip blower mounted on swivel base with single “S” pipe Hydraulic 30-HP super blower mounted on swivel base with single “S” pipe Hydraulic 40-HP chip blower mounted on a fixed base with dual “S” pipes and “Y” valve for dual loading Convert horizontal feed to drop feed chipper Convert 3-knife to 4-knife or 6-knife chipper 48” Chip-Pac 3-HP fines blower with 3-HP electric motor mounted on swivel base 0-HP electric chip blower with 10-HP electric motor mounted on swivel base with single “S” pipe 30-HP electric super blower with 30-HP electric motor mounted on swivel base with single “S” pipe Convert horizontal feed to drop feed chipper Convert 3-knife to 4-knife or 6-knife chipper Note: Specifications may vary with equipment options Blowpipe and Cyclone Overs return to chipper spout Double pump hydraulic system includes oil tank, valve bank, chipper sheave, and bushing, less base (D Model) Motor base including belt shield and take-up rails (E Model) Morbark Model 58”, 3-knife, horizontal feed, end discharge chipper (specify desired chip size setting) 6’ x 6’ Chip Screen with 2-HP hydraulic drive Blowpipe and cyclone Overs return to chipper spout Double pump hydraulic system includes oil tank, valve bank, chipper sheave, and bushing, less base (D Model) Motor base including belt shield and take-up rails (E Model) Morbark Model 48”, 3-knife, horizontal feed, end discharge chipper (specify desired chip size setting) 5’ x 5’ Chip Screen with 2-HP electric drive