Catalogs >
MONTECH >
Special Conveyor SOLTB

Special Conveyor SOLTB
2Pages

Catalog excerpts

more than technology SPECIAL CONVEYOR SOLTB The Special Conveyors SOLTB are used as feed or removal conveyors or for interlinking entire production lines; they are available with flat belts or as a special version with toothed belts. The Special Conveyor consists of a chassis with two belts which are guaranteed to run synchronously. The complete conveyor can be installed and removed from above, and belts can be replaced while the conveyor is installed. The Special Conveyor does not have any protruding edges. It will transport the sensitive wafers with the highest precision and gentlest care. > Easy belt change, even while installed Since the Special Conveyor has only very few components, the need for spares will be minimal. Broken wafers can fall out easily, as there is enough room between the belts. > Head drive optionally on the right or left side > Length and width according to customer specification > Available with flat belts or as a special version with toothed belts > Include drive components for Neugart gearhead PLE-40 (gear shafts Ø10 h7) Maxon gearhead GP 32 A (gear –0.004 shafts Ø 6 –0.015)

Open the catalog to page 1

Feet are not part of the scope of supply * Height individually definable S P E C I A L C O N V E Y O R S O LT B - T E C H N I C A L D ATA Weight SOLTB B=104 with 2 supports (without drive components): Head drive weight (L = 500 mm) Each additional support Weight SOLTB B=144 with 2 supports (without drive components): Head drive weight (L = 500 mm) Each additional support Required drive torque Motor (motor bracket) prepared for Ambient conditions: temperature Neugart gearhead PLE-40, Maxon gearhead GP32 A [°C] normal workshop atmosphere Warranty period Installation position Accessories: foot...

Open the catalog to page 2