Rubber Testing Solutions INNOVATIONS IN RUBBER TESTING

MonTech RP 3000 Rapid Plastimeter for Polymers and Natural Rubber The MonTech Rapid Plastimeter measures the plasticity or viscosity of polymers and unvulcanised rubbers. The test is simple, clean and quick. The instrument is typically used in conjunction with the MonTech ageing oven for plasticity testing to determine the Plasticity Retention Index (PRI) of raw natural rubbers. The variable temperature range from 25°C to 200°C for easier to read with freely programmable conditioning and load times allow a convenient characterisation of the flow behavior of natural and synthetic rubbers at variable...

Package including: The MonTech Plastimeter offers greatly enhanced operator access and is available in only one, full option version with all possible features included. One of the most important features is the powered zero and load calibration and automatic platen parallelism alignment totally eliminate the need for any manual setting of the instrument. The RP 3000 Rapid Plastimeter can be calibrated in less than 20 seconds! A strong aluminum and stainless steel frame, paired with direct linear drive technology ensures highest instrument rigidity and stability to guarantee the highest precision...

MonTech PO 3000 Ageing oven for Plasticity Testing The MonTech ageing oven for plasticity testing ages rubber in accordance with international testing standards. In conjunction with the MonTech Plastimeter, it allows the user to determine the Plasticity Retention Index (PRI) of raw natural rubbers. Housed in a robust stainless steel case, the MonTech ageing oven for plasticity testing features an aluminum block with four chambers that carry the drawer units and sample dishes. Heater elements are wrapped around and inside the block and high quality insulation inside the case minimizes heat loss....

PO 3000 - Sample loading made easy 1 - Remove drawer from the oven 2 - Place aluminum dish 3 - Install aluminum dish 4 - Remove installation tool 6 - Put drawer back in the oven to start the 30 minute ageing sequence Technical specification Standards Temperature Recovery 1 minute at 140°C after sample insertion Operating Temperature 140 ± 0.2°C (adjustable from ambient to +200°C) Chamber Dimensions Package including: Drawers loaded with samples  4 trays wish 4 dishes each  Electronic system with 4 independent timers, beeper and monitoring system Heating Chambers adjustable 0 to 120 times /...

Rubber Testing Solutions Werkstoffpriifmaschinen GmbH Carl-Benz-StraBe 11 D - 74722 Buchen / Germany Phone: +49(0)6281562230 Fax: +49(0)6281562255 [email protected] www.rubber-testing.com