EZstrip™ High Temperature Pump Application “A revolutionary new pump designed specifically for the transfer of thermal hydrolysis sludges at temperatures up to 130°C”. Capacity up to 225m3/h • Thermal hydrolysis sludges Pressure up to 12 bar Temperature up to 130oC The full drive train including rotor, stator, shaft, rod and seal can be removed in less than 4 minutes, with no electrical disconnection required. Rotor geometry Modified design to provide reliable performance demanded by the thermal hydrolysis process. Stator compounds New rubber stator compounds have been developed which are extremely resistant to the temperatures and aggressive liquids involved. Drive train assembly A pre-assembled drive train is available, with 2 year warranty, to allow an even faster re-assembly time. Eliminate dismantling Suction and discharge pipework can remain connected, so dismantling space is not lengths required. Materials of construction Available in cast iron with a choice of rotor materials to suit individual applications. Low running speeds Reduced wear for a longer working pump life which extends the periods between routine maintenance. Think of the savings you could make on abrasive applications. Gentle pumping action Minimises shear and crush damage to the pumped product. Robust drives Specially selected drives and gearboxes for longer life. Pumps can be supplied on a baseplate to ease installation. © Mono Pumps Limited May 2013 T. +44 (0)161 339 9000 E. [email protected] www.mono-pumps.com