Epoch TH series for High hardened steels EPP-TH Epoch TH Power Mill

Added TH Power Mill series Short, medium, long flute and corner radius are added into new line-up, and appropriate to cut all hardened steel. Features of EPP-TH01 Abundant variations! 18 short flute, 9 medium flute, 6 long flute and 35 corner radius new items are added into new line-up, and can handle all demands in slotting, side cutting and plunging. 02 High speed cutting of hardened steel is achievable! The tool shows its performance in various materials especially from pre-hardened steels (35HRC) to hardened steels. Power Mill design gives efficient chip flow. With the highly rigid design...

Wear width (when machining 10 holes) Epoch Power Mill -Short 08 Tool

Epoch TH Power Mill -Long 08 Machining shape ♦ Cutting surface in corner radius ♦ Comparison of cutting surface roughness in corner radius Rz 4.7^m Epoch TH Power Mill can greatly suppress the vibration in inside corner finishing machining. V.

Item code Item code ■ Tolerance on dia - Epoch TH Power Mill : Stocked items.

Item code Item code

Tolerance on dia. :Under table Tolerance on shank : h6 Item code ■ Tolerance on dia - Epoch TH Power Mill Tool dia. (Do)

Epoch TH Power Mill -Short Work material [Note] ® Use a highly rigid and accurate machine as possible. ® Use the appropriate coolant for the work material and machining shape. @ These conditions are for general guidance; in actual machining conditions adjust the parameters according to your actual machine and work-piece conditions. @ If the rpm available is lower than that recommended please reduce the feed rate to the same ratio. Work material

Epoch TH Power Mill -Regular Epoch TH Power Mill -Corner Radius < Slotting > Work material <Side milling > Work material

EPPM4-TH <Side milling > Work material Epoch TH Power Mill -Long EPPL4-TH <Side milling > Work material [Note] ® Use a highly rigid and accurate machine as possible. ® Use the appropriate coolant for the work material and machining shape. @ These conditions are for general guidance; in actual machining conditions adjust the parameters according to your actual machine and work-piece conditions. @ If the rpm available is lower than that recommended please reduce the feed rate to the same ratio.

Re-grinding Re-grinding compatibility range table Item Code Product Name Line up tool dia.(mm) Re-grinding compatibility range (mm) Epoch TH Power Mill -Short Epoch TH Power Mill -Regular Epoch TH Power Mill -Medium Epoch TH Power Mill -Long Epoch TH Power Mill -Corner radius

The diagrams and table data are examples of test results, and are not guaranteed values. "Epoch" and “ ” are registered trademarks of Mitsubishi Hitachi Tool Engineering, Ltd. in Japan. Attentions on Safety 1. Cautions regarding handling (1) When removing the tool from its case (packaging), be careful that the tool does not pop out or is dropped. Be particularly careful regarding contact with the tool flutes. (2) When handling tools with sharp cutting flutes, be careful not to touch the cutting flutes directly with your bare hands. 2. Cautions regarding mounting (1) Before use, check the outside...