Exchangeable head End Mill for Die & mold making

Exchangeable Head End Mills for Die & mold making EHX End M ill s e r ie s “Carbide” +“Carbide” = “High accuracy & High rigidity” Double Face Contact Type Special Steel Screw Joint Mono-block Carbide Holder Available with Internal Coolant Double Face Contact Type (Taper + End Face) The EHX series is a revolutionary end mill system that enables Comparison of tool rigidity efficiency, high accuracy and rigidity by combining the advantages The double face contact of the carbide head and of both solid carbide and indexable end mills. carbide holder gives an increase in rigidity of 30%. Security and...

First shot Deploy three favorable solid end mills to the EHX series Item code Head type Roughing process of mold can be done withhigh efficiency. Epoch Turbo Mill High-speed cutting for high hardness materialsis possible Cover a wide range application from roughing to finishing. Epoch Power Mill Tool life is comparable to the soild end mill. Work material：STAVAXⒽ(52HRC)　Tool dia.： φ12　 Machine：HSK-A63　 Cutting length：L=50m n=5300min-1 (vc=200m/min) vf =2800mm/min (fz=0.088mm/t) ap×ae=6mm×0.2mm　Dry(Air Blow)　Down Cut Conventional exchangeable head (L=10m) Advanced TH coating dedicated to the exchangeable...

Roughing process of mold can be done with high efficiency. Head type : Epoch Turbo Mill : Stocked Items

Cover a wide range application from roughing to finishing. Head type : Epoch Power Mill Curved edge Curved edge Carbide ATH-Coated Helix angle Size (mm) Item code Corner radius Flute length Overall length L r R Re-grinding compatibility range table Item Code Product Name Re-grinding compatibility range (mm) Exchangeable head end mill EHX-ETM Exchangeable head end mill EHX-H-ETM

Straight type Pencil neck type

O How to Install the Head Using a clean cloth, wipe away oil and dust from the taper and end surfaces of the head and holder. Be careful to avoid the possibility of cutting hands when fastening with bare hands directly near the blade tip. Securely fasten the head and holder end surfaces using the enclosed spanner to close off any remaining gap. Refer to the table at right regarding angles for recommended torque when necessary. For stricter usage, refer to the table right for torque wrench fastening. Suitable head (Note) Use the enclosed spanner only. (Typical spanners differ in thickness.) O...

When using a holder with a long overhang length, please use the correction factor of the above table in consideration

When using a holder with a long overhang length, please use the correction factor of the above table in consideration.

When using a holder with a long overhang length, please use the correction factor of the above table in consideration. © Use the appropriate coolant for the work material and machining shape. © Use a highly rigid and accurate machine as possible. © These Recommended Cutting Conditions indicate only the rule of a thumb for the cutting conditions. In actual machining, the condition should be adjusted according to the machining shape, purpose and the machine type. © If the rpm available is lower than that recommended please reduce the feed rate to the same ratio.

Work material :DAC0(45HRC) Size :150x150x100mm(Cutting depth 86mm)Machine :HSK-A63Tool Process EHX12-ETM4120-20-TH After 54 minutes processing Processo

The diagrams and table data are examples of test results, and are not guaranteed values. "Epoch" and “ ” are registered trademarks of Mitsubishi Hitachi Tool Engineering, Ltd. in Japan. Attentions on Safety 1. Cautions regarding handling (1) When removing the tool from its case (packaging), be careful that the tool does not pop out or is dropped. Be particularly careful regarding contact with the tool flutes. (2) When handling tools with sharp cutting flutes, be careful not to touch the cutting flutes directly with your bare hands. 2. Cautions regarding mounting (1) Before use, check the outside...