r MLS SERIES - HI CHROME SLURRY & SAND SUBMERSIBLE PUMP MLS SERIES ELECTRIC SUBMERSIBLE SLURRY & SAND PUMP - 28% HI-CHROME DESIGNED FOR PORTABLE AND ABRASIVE APPLICATIONS MATERIALS OF CONSTRUCTION AND ENGINEERING DATA Impeller Type Semi-Open Max. Temperature of Pumped Fluid: 104°F/40°C MOTOR 4-pole induction continuous rated motor with squirrel cage rotor. Automatic ON/OFF/ON Thermal Overloads in Motor. (5-12HP) Stator insulation class 'F (155°C), 1.15 Service Factor. POWER SUPPLY 3 phase, 60 Hz, AC Supply, 208, 230,460,575. Other voltages available upon request. BALL BEARINGS The rotor shaft is carried in two ball bearings. Double row contact lower bearing is capable of carrying high thrust and radial loads. Upper bearing is a deep groove single row oversized bearing. The bearings are enclosed with high temperature grease-containing special Anti-corrosion additive. POWER CABLE Waterproof/oil proof, rubber-insulated, neoprene-sheathed copper conductor flexible cable, 50 ft. (15m) length standard. Type SOOW in North America, EPR in the Middle East and HO7RN in the EU. SHAFT SEALS Double Mechanical Seals, outer and inner are Silicon Carbide, both rotating and stationary faces. HYDRAULICS Multi Vane, Semi-Open Impellers to effectively handle abrasive media. COOLING Top discharge ensures that the pump is cooled by the pumped liquid allowing the pump to operate even if not completely submerged. MATERIALS OF Pump Casing: Stator Casing: Impeller: Wear Plate: Agitator Shaft: Hardware: "O” Rings: Mech. Seals: CONSTRUCTION ASTMA-48 ASTMA-48 28% Hi-Chrome Iron 28% Hi-Chrome Iron 28% Hi-Chrome Iron 403 Stainless Steel 304 Stainless Steel Nitrile Rubber SC/SC (Upper & Lower) SURFACE TREATMENT Primer with Epoxy paint Mody Pumps® Inc. 2166 Zeus Court, Bakersfield, CA 93308. USA Tel.: (661) 392-7600 • Fax: (661) 392-7601 http://www.modypump. com E-mail: [email protected]

MLS SERIES - HI CHROME SLURRY & SAND SUBMERSIBLE PUMP MLS SeriesPortable Wet Pit InstallationDIMENSIONS CHART (inches)MODEL ABC MLS3-5 Performance Curve based on Clean Water at 68° F with 1.0 SG. Due to continuous product development, specifications are subject to change without notice. Vol. 1, Rev. 1, Nov. 2018