Our products and solutions meet your needs 70 years of experience and innovation for you SOLUTIONS FOR HEAVY AND LIGHT-DUTY BELTS MANUFACTURER OF TECHNICAL BELTS, TOOLS, VULCANIZING PRESSES

CL Lacer Technical characteristics Compact and easy to handle, the CL Lacer makes it easy for you to install your fasteners! The MLT team has designed the CL Lacer in order to facilitate the installation of your Clip’N Lock® fasteners. This compact and lightweight installation tool allows you to complete the installation of the fastener quickly and easily. A power supply is not necessary. The handy CL Lacer is can be used in all types of jobs. In addition, the CL Lacer is delivered ready-to-use. Assembly is not necessary before using the Clip’N Lock®. Only the closing handle must be raised and...

Preparation :For quick and easy installationSimply choose your Clip’N Lock®:

Mode of use : How to install Clip’N Lock® fastener with CL Lacer Adapt the comb to the width of the belt Recommendation : Add a belt clamp for a better maintenance of the device. Recommended table height: 75 cm / 30 inches 1. Determine the size of the Clip’N Lock® fastener according to the thickness of your belt. Then select the appropriate comb. See table on page 4. 3. Cut the fastener according to the width of the belt. Remember to remove the clip from the strip 3 to 5 mm on each side. 4. Place the clip in position on the comb suitable for Clip’N Lock®. Insert the pin. Unlock the comb holder...

12. For a strip width greater than 300mm: After pre-closing the 1st length of the fasteners, when the box is in stop: * Open the locusts, then: Move the strip by sliding the comb through the comb holder. OR Move the CL LACER by sliding the comb into the comb holder. * Lock the clamps again. * Pre-close the 2nd staple length. 13. Closing the clip: 2nd pass • To close the CL25 to CL 40 clip, position the pin in the CL25/30/40 - 2 slot. • To close the CL50 clip, position the pin in the CL50 -2 slot. Repeat steps 9 to 12. 14. Once the belt width is com plete: remove the holding pin. 15. Unlock the...

MLT – it’s also metallic fasteners, flexible splices, tools, endless and spliceless technical belts ISC® belt SUPER-SCREW® FIX’N GO® Innovative products, easy to install ! Clip’N Lock® Technical belt Endless splic

MLT Minet Lacing Technology SA ZI du Clos Marquet Tél: + (33) 4 77 22 19 19 Rue Michel Rondet - CS 70059 Fax: +(33) 4 77 22 56 43 42 400 St Chamond [email protected] France www.mlt-lacing.com MLT, it’s solutions for heavy and light duty belts, tools, technical belts, etc.