The special alloy binder with increased thermal conductivity has dramatically improved the thermal shock resistance properties. This gives a highly stable cutting edge performance even when wet cutting where conventional cermet grades usually exhibit an unstable and unpredictable performance. > The special alloy binder has improved the binding of the hard substrate particles. Abnormal damage such as thermal cracks and micro-chipping are prevented and the superior surface finishes specific to cermet grades can be maintained. > Please use NX2525 grade for dry cutting only or with non-water soluble...

Material BreakerFeaturesCross Section Geometry > First recommendation for finishing general steel and alloy steel > 12 FlankNose Depth of cut Double sided chipbreaker.Stable chip control even at small depth of cut. > 12а First recommendation for light cutting of general steel and alloy steel > 15 0.2 FlankNose Double sided chipbreaker. > Can be used at low depths of cut at high feed rates. The curved edge allows smooth chip discharge. > 15а Recommended for workpieces in the 160─250HB range. > First recommendation for medium cutting of general steel and alloy steel > 22 0.26а FlankNose 1st Recommendation...

MITSUBISHI MATERIALS ESPAA, S.A. MMC HARDMETAL U.K. LTD. C/Emperador 2, 46136 Museros, Valencia, Spain Tel. +34-96-144-1711 Fax +34-96-144-3786 e-mail [email protected] > ul. Bolschaja Pochtovaja, d.36, str.1 105082 Moscow, Russia Tel. +007-095-72558-85 Fax +007-095-72558-85e-mail [email protected] MMC HARTMETALL GmbH MITSUBISHI HARDMETAL RUSSIA OOO LTD. Comeniusstr. 2, 40670 Meerbusch, Germany Tel. +49-2159-91890 Fax +49-2159-918966 e-mail [email protected] > Mitsubishi House, Galena Close, Tamworth, B77 4AS, U.K. Tel. +44-1827-312312 Fax +44-1827-312314e-mail [email protected]...