Catalogs >
Misumi America >
INCLINED PINS ? DIRECT PUSH-UP PINS ?

INCLINED PINS ? DIRECT PUSH-UP PINS ?
1Pages

Catalog excerpts

INCLINED PINS ? DIRECT PUSH-UP PINS ? - 1

INCLINED PINS・DIRECT PUSH-UP PINS② BOTH ENDS TAPPEDBOTH ENDS STEPPED TYPE V Non JIS material definition is listed on P.1359 - 1360 ■KKSPSC Both ends tapped type (Tap size : compact) M Part Number Type D 12 16 KKSPSC 20 25 30 ■KSPSC Both ends tapped type (Tap size : normal) Both ends tapped type (Tap size : compact) (Tap size : normal) M R SUJ2 Q 58HRC S Induction hardening (depth : 0.5mm or more) Both ends stepped type KKSPSD KSPSD (Tap size : compact) (Tap size : normal) C0.5 or less W ・ hen connecting the inclined pin and inclined block, use a dowel pin, etc. to fix them after preparing a common hole. T ・ he inclined pin's full length (L) is set in the positive range of tolerance in order to accommodate for fine adjustment. Quantity Rate T V o be quoted on price & lead time above Max. Q'ty. Flat edge chamfering (1 plane) V Adds new chamfering applicable to KKSPSC・KSPSC. ■Quantity discount rate X P.45 Part Number V Delivery days depend on subsidiary. X P.45 * The area (D dimension wise) within 10mm or so from the machined section may have a lower hardness due to annealing. O ・ verall induction hardening is applied to K KSPSC and KSPSC (both ends tapped type). Flat edge chamfering (2 planes) V Applicable to KKSPSC・KSPSC B1mm increments, K1mm increments U Not available for D8・10 10≦B≦50 LBF≧10 V SCW Designation method SCWB16K17 D K D K 12 20 14≦K≦18 8≦K≦10 16 10≦K≦14 25 19≦K≦24 30 20≦K≦29 Slide Cores Loose Cores About shaft end processing I ・nduction hardening is not applied since machining of shaft ends and key flats are performed after annealing. ■Dimension contrast table Part Number Part Number Type D Tap size : Compact Normal Compact Normal Standard type (SCZN・SCZA) KKSPSC KKSPSD M Inclined block Slide unit Corresponding oil-free slide units R SUJ2 Q 58HRC S Induction hardening (depth : 0.5mm or more) ■KSPSD Both ends stepped type (Tap size : normal) Part Number Type D ■KKSPSD Both ends stepped type (Tap size : compact) KKSPSC KSPSC ・Note that inclined pins of D8 and D10 corresponding to the standard are not on sale. Delivery days depend on subsidiary. Non JIS material definition is listed on P.13591360.

Open the catalog to page 1