Milltronics 7200 Control Panel 7200 Series CNC TIPS are applicable to the Milltronics 7200 Series controls. Power ON: The main power switch is located on the electrical cabinet at the back of the machine. When main power is switched on, the power to the CNC is also applied. Power OFF: Before switching off the main power, press the E-Stop button to ensure the machine is in emergency stop mode. Copyright © 2010 by Milltronics CNC Machines, 1400 Mill Lane, Waconia, MN 55387 USA

Milltronics 7200 Control Panel Page 2 Continued 1. Manual Pulse Generator (Handwheel): Rotate this wheel to control axis feed while in HDW mode. 2. Feedrate Override Switch: Labeled in percentages. Controls the feedrate and rapid traverse (exception - see #3) of the machine axes. Also affects handwheel rate. 3. Rapid Override Buttons: By selecting 10% or 100%, rapid will run at the selected rate regardless of feedrate override control. By selecting “%”, the feedrate override setting controls the rapid speeds. 4. Cycle Start Button: Starts automatic operation. In most cases the control will prompt...