product information www.miller-stephenson.com Contact Re-Nu® MS-530 (Aerosol) MS-532 (Bulk Liquid) A cleaning agent that restores electrical or mechanical continuity on all types of contacts. Excellent for cleaning oxides, oil, grease and dust from contacts, switches, relays, tuners, encoders, slide wires, rheostats, distribution panels and servomechanisms. Evaporates quickly and leaves no residue. Evaporates quickly Leaves no residue RoHS compliant PLASTIC COMPATIBILITY: (Immersion: 15 minutes at Room Temperature) Acetal Polypropylene Polyester, PBT, PET Polysulfone, PSO Polyimides Phenolic Butyl Rubber Polysulfide Buna S Neoprene Chlorosuflonated PE Viton®B Natural Rubber EPDM Buna N Urethane Silicone Elastomer swelling and shrinking will, in most cases, revert to within a few percent of original size after air drying. Swell, shrinkage, and extractables are strongly affected by the compounding agents, plasticizers, and curing used in the manufacture of the elastomers. Test for compatibility before use. TYPICAL PROPERTIES: ELASTOMER COMPATIBILITY: (Immersion: 15 mins at Room Temperature) Polyethylene Liquid Crystal Polymer Epoxy PEK, PEEK PTFE Polyvinylchloride METAL COMPATIBILITY: (Immersion: 2 weeks at 99°F/37°C)    Aluminum Copper Iron Note: Test for compatibility before use. Safety Data Sheets (SDS) are available upon request. For technical support: 800-992-2424 (8-4 E T) in the U.S. 800-323-4621 (8-4 E T) in Canada. e-mail: [email protected] NOTE: Acrylics, ABS, and polycarbonate, if under stress, may show slight cracking or crazing damage. Test for compatibility before use. Viton® is a registered trademark of E.I. duPont de Nemours and Company or its Affiliates. Contact Re-Nu® is a registered trademark of Miller-Stephenson. . 1448-6J The recommendations made here with and the information set forth with respect to the performance or use of our products are believed, but not warranted to be accurate. The products discussed are sold without warranty, as to fitness or performance, express or implied and upon condition that purchasers shall make their own test to determine suitability of such products for their particular purposes. Likewise, statements concerning the possible uses of our products are not intended as recommendations to use our products in the infringement of any patent. CONNECTICUT Miller-Stephenson Chemical Co.,Inc. 55 Backus Avenue Danbury, Connecticut 06810 U.S.A. 203 743-4447 Fax 203 791-8702 ILLINOIS Miller-Stephenson Chemical Co.,Inc. 6348 Oakton Street Morton Grove, Illinois 60053 U.S.A. 847 966-2022 Fax 847 966-8468 Miller-Stephenson Chemical Co., Inc. 12261 Foothill Boulevard Sylmar, California 91342 U. S. A. 818 896-471