Plastics Technologies M-KKI Model - Signature Line, Steel Frame, Flat-to-Adjustable Angle Conveyor Standard Features Adjusts from 20° to 45° (12° to 45° for some models). Direct Drive 1/3 HP 110/60/1 C-Faced Drive package No roller chain or sprockets. Sealed gear reducer. 12 gauge steel construction. Double V-guided, FDA approved, white PVC belt with 1V: flexible cleats on 18" centers. 4" high side rails lapped over the conveyor belt with Lexan infeed flapper. Bottom slide tray protects cleats. Leg sets (Adjustable up to 34" infeed belt height -specify infeed and discharge belt heights) and swivel castors included. 15' power cord included. Pre-wiredr ready-to-run (except on polyphase systems which require customer wiring). Control wiring contained in liquid-tight conduit Units ship fully assembled. Belt Widths Note: See conveyor specifications page for motor Incline Section Adjustment Screw Note: M-KKI shown with 12 gauge steel support leg stand set with leveling screw and castors. Standard Models Available in 6 widths, and length increments of V. For 6", 9", 12", and 18" belt width models the motor Minimum infeed length 1', maximum is 7'. Minimum discharge length 2'. Infeed plus discharge lengths can not exceed 15 ft. For 24" and 30" belt width models, the motor is located Minimum infeed length 2ft, maximum is 7'ft. Minimum discharge length 1ft. Infeed plus discharge lengths can not • Standard starter position (specify if other location). infeed belt height w/standard Milacron Marketing Company * Specialty Equipment Business 4165 HaHacre Road * Batavia, OH 45103 * Tel: 513.536.2581 * Fax: 513.536.2321 * http://plastics.milacron.com