HL3040
4Pages

HL3040 series booster Air / Inert Gas Pressure Booster 1.5 HP 115V AC / 230V AC Electric motor 24/7 operation 20 - 140 psi gas inlet pressure 650 psi max gas discharge pressure 10,000 hours of seal life Air-cooled / Oil free MPS Midwest Pressure Systems, Inc. M I DWEST PRESSURE SY S T E M S Touchscreen control panel 850 Transport Drive Valparaiso, IN 46383 www.midwestpressuresystems.com 2" Square

Booster Specifications: HL3040 series Gas Connections & dimensions Gas supply connection Bore diameter and stroke length 0.061 cubic feet (1.73 liters) Recommended fluid 3.5 Gallons Electrical Specifications Rated voltage Supply cable Power consumption Pressure, Temperature & Noise Specifications Gas supply pressure range Gas discharge pressure range 20 psig to 140 psig (1.4 bar to 9.7 bar) 200 psig to 650 psig (13.8 bar to 44.8 bar) Ambient temperature range - ºF (ºC) Noise Emmission5 Duty cycle Note 1: Breather installed at the factory Note 2: A cycle consists of a forward and reverse...

Performance Data: HL3040 The HL3040 gas pressure booster provides flow rates between 45 SCFH and 190 SCFH depending on the gas supply pressure. Installing a regulator upstream of the booster allows the operator to set the desired flow rate. Example: A nitrogen generator is capable of delivering 99% nitrogen at 90 SCFH and 80 psig. However with an 80 psig supply the booster will produce over 115 SCFH. 115 SCFH is more than the nitrogen generator is capable of providing so a loss in purity may occur as the nitrogen generator attempts to provide more flow. This can be remedied by regulating the...

Touchscreen Control Panel: HL3040 The HL3040 gas pressure booster uses a touchscreen control panel. The touchscreen allows the operator to turn ON and OFF the system, view & change various operating parameters and review error codes. An example of the Home Screen is shown below along with a list of the viewable/modifiable parameters. Viewable Parameters Output Pressure The current discharge pressure of the system High Pressure Setting The pressure at which the system will automatically turn OFF (Modifiable by the operator) The pressure at which the system will automatically turn ON...