Catalogs >
MICRO-CONTROLE / Spectra-Physics >
Spitfire® Pro XP 7 W Ultrafast Amplifier

Spitfire® Pro XP 7 W Ultrafast Amplifier
2Pages

Catalog excerpts

Spitfire® Pro XP 7 W Ultrafast Amplifier - 1

Spitfire® Pro XP 7 W Ultrafast Amplifier H I G H P O W E R A N D M A R K E T L E A D I N G B E A M Q U A L I T Y The Spitfire Pro XP 7 W Advantage • Patented regenerative cavity provides minimum intracavity dispersion and losses • Multipass amplifier provides up to >7.0 W of output power • Pulse widths as short as 40 fs • Available in 1 kHz, 5 kHz and 10 kHz configurations • Superior mode quality (M2 <1.5) • All-digital timing provides superior long-term stability and full computer control • Supported by the most knowledgeable and experienced ultrafast engineering and service teams A P P L I C A T I O N S • Multicolor pump-probe spectroscopy • Coherent control • Nonlinear optics • Time resolved spectroscopy • Four wave mixing spectroscopy • Material processing • Optical parametric amplification Specifications1 Output Characteristics Spitfire Pro 40F-7W Spitfire Pro F-7W Spitfire Pro PM-7W Pulse Width2, 4, 5 <40 fs <120 fs <2 ps Repetition Rate3 1 kHz, 5 kHz or 10 kHz Pulse Energy2 (1 kHz) >7 mJ Pulse Energy2 (5 kHz) >1.4 mJ Pulse Energy2 (10 kHz) >0.7 mJ Pre-Pulse Contrast Ratio6 >1000:1 Post-Pulse Contrast Ratio7 >100:1 Energy Stability8 <0.75% rms over 8 hours Tunability9 780–820 nm 750–840 nm 750–840 nm Transform Limit10 <1.5 x transform limit Spatial Mode TEM00 (M2 <1.5 on both axes) Beam Diameter (1/e2) 7 mm (nominal) Polarization Linear Horizontal 1. Due to our continuous product improvements, specifications are subject to change without notice. The specifications only apply when Spitfire Pro is operated with recommended Spectra-Physics seed and pump lasers. 2. Applies at peak wavelength (800 nm). 3. The desired optimum repetition rate should be specified at time of purchase. If optimum performance is required at more than one repetition rate, additional optic sets may be required. Any system can be operated (with the same energy per pulse) at reduced repetition rates through internal divide-down electronics. 4. A Gaussian pulse shape (0.7 deconvolution factor) is used to determine pulse width (FWHM) from autocorrelation signal as measured with Newport PulseScout® autocorrelator. 5. For other pulse widths, please contact Spectra-Physics. 6. Defined as the ratio between peak intensity of output pulse to peak intensity of any pulse that occurs >1 ns before the output pulse. For higher contrast ratio, please contact Spectra-Physics. 7. Defined as the ratio between peak intensity of output pulse to peak intensity of any pulse that occurs >1 ns after the output pulse. For higher contrast ratio, please contact Spectra-Physics. 8. Applies at peak wavelength: % rms with near Gaussian distribution. 9. For wavelength extension through SHG, THG, FHG or OPA, please contact Spectra-Physics. 10. Assuming Gaussian pulse shape. Spitfire Pro XP 7 W Dimensions 8.50 (21.6) 6.25 (16.0) 9.40 (23.9) 33.0 (83.8) 11.5 (29.2) 3.35 (8.51) 5.90 (15.0) Seed Beam Input Port 1 Seed Beam Input Port 2 0.75 (1.91) 60.0 (152) 4.90 (12.4) 2.00 (5.08) 7.50 (19.1) 29.0 (73.7) Pump Beam Input Port 2 Pump Beam Input Port 1 Output Port Dimensions in inch (cm) Side View, Seed Input Panel Pump End View Output End View

Open the catalog to page 1

Spitfire® Pro XP 7 W Ultrafast Amplifier - 2

DS-05093 Spectra-Physics® Lasers Sales: 1-800-775-5273 sales@spectra-physics.com www.newport.com/lasers PHONE EMAIL Belgium +32-(0)0800-11 257 belgium@newport.com China +86-10-6267-0065 china@newport.com France +33-(0)1-60-91-68-68 france@newport.com Italy +39-02-92-90-921 newport@tin.it Japan +81-3-3794-5511 spectra-physics@splasers.co.jp Taiwan +886 -(0)2-2508-4977 sales@newport.com.tw PHONE EMAIL Mtn. View, USA +1-800-775-5273 sales@spectra-physics.com Netherlands +31-(0)30 6592111 netherlands@newport.com United Kingdom +44-1235-432-710 uk@newport.com Germany / Austria / Switzerland...

Open the catalog to page 2