Catalogs >
MICRO-CONTROLE / Spectra-Physics >
Oriel TE Cooler Controller

Oriel TE Cooler Controller
1Pages

Catalog excerpts

1242 Phone: 1-800-222-6440 • Fax: 1-949-253-1680 S p e c t r o s c o p y I n s t r u m e n t s MONOCHROMATORS AND SPECTROGRAPHS BENCHTOP SPECTROMETERS MINISPECTROMETERS SINGLE CHANNEL DETECTION SYSTEMS AND CCD CAMERAS ACCESSORIES FOR FT-IR SPECTROMETERS SPECTROSCOPY INSTRUMENTS Oriel TE Cooler Controller 77055 TE Cooler Controller Operation at decreased, controlled temperatures helps lower the noise levels of many detectors and stabilize their responsivities. Our Cooler Controller provides temperature control to any of our cooled detectors. You can also use this 1.25 A current capacity controller with your own TE cooled device, within the controller's operating range. Please check temperature sensor compatibility and current and voltage drive requirements if you plan to use the 77055 with other manufacturers’ detectors or other cooled devices. Cooling and Heat Control The 77055 Controller has been designed for easy setup and reliable, safe operation. The primary controls are a three digital thumb pot for a setting temperature (actually thermistor resistance) and a cooler on/off switch. LEDs indicate cooler on, cooling in process, and cooler ready. Remote cooler on/off control input (TTL) and cooler ready output (TTL) signals are provided. The current limit setting will prevent overdriving TE modules. The power supply is of a linear type to provide low noise power to the detector's TE modules and avoid becoming an additional noise source. Not Just for Oriel Cooled Detectors The 77055's use is not limited to Newport's Oriel Detectors. The flexibility of this controller supports use in a wide range of temperature control situations. If your power requirements are 3.75 watts or less (1.25 A max) and the temperature sensing device is an NTC thermistor, the 77055 will provide stable and convenient operation. Other Features • Remote cooler on/off control (TTL) • Cooler ready output (TTL) • Convenient 9 pin D-sub output connector • Control detector temperature with confidence • Provide precise and reproducible control • Optimized for optical detectors Specifications Temperature Control Range* themistor dependent Temperature Stability <0.1 °C Set Point Resolution 100 Set Point Accuracy ± 200 Ù Thermistor Range 100 Ù to 99.9 k Maximum Current 1.25 A Maximum Voltage 3.9 V Total Power 3.75 W Power Requirements 0.25 A @ 95-132 VAC, 50/60 Hz 0.125 A @ 190-264 VAC, 50/60 Hz * Actual temperature range is determined by the controlled device. The thermal load, TE module and sensor type all affect the temperature range. Ordering Information Model Description 77055 TE Cooler Controller

Open the catalog to page 1

Oriel TE Cooler Controller 1Pages

Catalog excerpts

All MICRO-CONTROLE / Spectra-Physics catalogs and technical brochures

Oriel TE Cooler Controller
1Pages