Super-mini Signal Conditioners Mini-M Series INSTALLATION BASE (16 positions) Functions & Features • Receiving at the maximum of 16 modules of Mini-M series signal conditioners • Screw terminal or connector output • Power supplied through printed wiring on the base GENERAL SPECIFICATIONS_ Power input: M3 screw terminals (torque 0.8 N'iri) Input and output: M3 screw terminals (torque 0.8 N'iri) Screw terminal: Nickel-plated steel Power input: Refer to signal conditioner data sheet. Choose the same power input specification for all units. Operating humidity: 30 to 90 %RH (non-condensing) Mounting: Surface; optional DIN rail mounting available for M2BS-16U1, U2 (in horizontal direction only) Insulation resistance: > 100 MO with 500 V DC (input to output to power to FG) Dielectric strength: 2000 V AC @1 minute (input to output to power to FG) ORDERING INFORMATION_ Specify a code from below for each of [1] and [2]. (e.g. M2BS-16U2/D/UL) U0: Screw terminal block U1: Fujitsu FCN type I/O connector (UL not available) U2: Omron I/O connector [2] OPTIONS (multiple selections) Mounting blank: Surface /D: DIN rail mounting adaptor (Not selectable for M2BS-16U0) Standards & Approvals RELATED PRODUCTS_ • Connector terminal block (model: CNT) • Special cable with 40-pin connector (model: FCN) STANDARDS & APPROVALS_ EMC Directive EMI EN 61000-6-4 EMS EN 61000-6-2 Low Voltage Directive EN 61010-1 Installation Category II Pollution Degree 2 Input or output to power: Reinforced insulation (300 V) Input to output: Basic insulation (300 V) RoHS Directive The UK legislations and designated standards are equivalent to the applicable EU directives. (Refer to our website for more information about the legislations and designated standards.) UL/C-UL nonincendive Class I, Division 2, UL/C-UL general safety requirements (UL 3111-1, CAN/CSA-C22.2 No.1010-1) Voltage at the field I/O terminals (except power input terminals) limited within 30 V DC for UL.

MODEL: M2BS-16 CONNECTION DIAGRAM ■ MODEL: M2BS-16U0 (screw terminal block) ■ CONNECTION DIAGRAM 9 Ch.1 OUTPUT 12 ■ MODEL: M2BS-16U1 (Fujitsu FCN type I/O connector) • Connector Pin Assignment

MODEL: M2BS-16 ■ MODEL: M2BS-16U2 (Omron I/O connector) • Connector Pin Assignment

*165 (6.50) required for pneumatic tubing for M2PV. **Attached to M2CA and M2CE.

MODEL: M2BS-16 MOUNTING REQUIREMENTS unit: mm [inch] ■ M2BS-16U0 460 [18.11] *Installed in horizontal direction only. Specifications are subject to change without notice.