Screening and Conveyor Solutions Trellex Cer-Lag ceramic pulley lagging Optimized belt friction in any condition

Friction in any condition A lack of friction between the conveyor belt and pulley causes slippage—always a concern in difficult working conditions, especially when it’s wet or muddy. Besides the obvious belt damage, the need to compensate with higher belt tension puts added stress on all conveyor components, including rollers and bearings. Trellex® Cer-Lag pulley lagging is an easy, costeffective way to ensure optimal belt tension in any condition, minimizing the risk for expensive stoppages, maintenance and damage. • Increases friction between drive pulley and belt, especially in wet and muddy...

An investment in better performance Trellex Cer-Lag pulley lagging optimizes friction between the pulley and belt, protecting your belt and conveyor system and minimizing costly work interruptions. Cer-Lag’s circular ceramics are profiled for fluid drainage, providing grip in all conditions. Their design and vulcanized Trellex T60 rubber shell ensure increased wear life and less abrasion to the belt compared to square ceramics, meaning fewer stops for maintenance. Conveniently available with or without a contact layer, Trellex Cer-Lag is also easy to install by cold gluing. Your conveyor belt...

Metso Minerals (Sweden) AB Screening and Conveyor Solutions P.O. Box 132 SE-231 22 Trelleborg Sweden Phone: +46 410 525 00 Fax: +46 410 526 02 www.metsominerals.com For contact with your local Metso representative, visit www.metsominerals.com/trellex Subject to alteration without prior notice.