Catalogs >
MeterTest >
DC CHECK DIRECT CURRENT CHECK MODULE

DC CHECK DIRECT CURRENT CHECK MODULE
1 / 2Pages

Catalog excerpts

DC CHECK DIRECT CURRENT CHECK MODULE - 1

DIRECT CURRENT CHECK MODULE DC CHECK DIRECT CURRENT CHECK MODULE □ Broad current range □ DC and even harmonics influence check □ Compliance with IEC 62053-23, IEC 62053-21

Open the catalog to page 1

DC CHECK DIRECT CURRENT CHECK MODULE - 2

INTRODUCTION With the DC Check direct current check module, it is possible to test for and determine the effects of direct current and even harmonics, and is designed according to the schema presented in the IEC 62053-21 and IEC 6205323 standards. Any number of meters under test (MUT) can be connected to the DCCM in series but they should be balanced by an equivalent impedance that is equal to the impedance of all MUTs. Typically, devices of the same type as the MUT are used as the balancing impedance. Maximum current through the DCCM should not exceed 120 A. For additional technical...

Open the catalog to page 2

DC CHECK DIRECT CURRENT CHECK MODULE 1 / 2Pages

Catalog excerpts

All MeterTest catalogs and technical brochures

DC CHECK DIRECT CURRENT CHECK MODULE
1 / 2Pages