BIOZINC - EN

Product catalog summary

Introduction
Metalnastri Biozinc is a product designed to prevent the growth of moss, algae, mildew, and fungus on various surfaces such as roofs, concrete, and asphalt. It is environmentally friendly, composed of high-purity zinc (minimum 99.95%) with a thickness of 0.150 mm, and features an electro-conductive adhesive of 0.05 mm thickness.

Specifications
The product is available in standard widths of 50 mm, 100 mm, 150 mm, 250 mm, and 300 mm, each with a length of 20 meters. The zinc layer is 0.15 mm thick with a purity of at least 99.95%. The adhesive layer is 0.030 mm thick, with a weight of 50 gr/m2 and electrical conductivity of 10 Ohm/m2. The paper layer weighs 90 gr/m2 and is 0.075 mm thick.

Features
Metalnastri Biozinc is easy to install without invasive mechanical fixing, ensuring no damage to the underlying surface. The adhesive allows continuous contact with the surface, enhancing its fungicidal effectiveness. It is malleable, allowing for application on complex shapes, and can be layered for additional protection. The product has a lifespan of 10 years or more, with periodic checks recommended.

Main Uses
Primarily used to inhibit unwanted growth on roofs and other surfaces, it is recommended to install the product at roof ridges or hips to ensure rainwater distributes zinc across the surface.

Application Procedure
Surfaces must be clean, dry, and free from contaminants before application. The temperature should be above 0°C and at least 3°C above the dew point. The product is self-adhesive; the protective paper should be removed just before application to avoid contamination. After application, zinc oxidizes and releases zinc oxide molecules, which act as a fungicide.

Technical Data
The total weight of the product is 1190 gr/m2. The adhesive strength increases from a minimum of 6 N/cm after 10 hours to 8.5 N/cm after 48 hours. The product can withstand temperatures up to 70°C during normal operation and up to 90°C for short periods.

Catalog excerpts

ANTICORROSION SYSTEMS "Metalnastri Biozinc" product is properly designed to inhibit the growth and formation of moss, algae, mildew and fungus on roofs, concrete, asphalt and other surfaces where growth can occur. The product is environmentally friendly and it is composed by a laminar zinc of high pureness ( minimum 99,95% of zinc) ,with a thickness of 0,150 mm, and an electro-conductive adhesive with a thickness of 0.05 mm.. "Metalnastri Biozinc" "Metalnastri Biozinc" is available in standard widths: Width FEATURES "Metalnastri Biozinc" is different from all the other similar products in commerce, actually it presents some effective and practical features: • It is very easy to install, in fact it doesn't require any type of invasive mechanical fixing that can cause damages to the underlying surface and can compromise the correct operating of the system. The presence of a special adhesive guarantees an excellent bonding on all the surfaces that have to be covered. • The adhesive coat, which is applied only on one side of the zinc tape, consists of a special chemical composition. With this formulation , combined to a particular additives, we have achieved the most important effect, in fact it allows a direct and continuous contact of the zinc with the surface that has to be covered. This permits to Metalnastri BioZinc to act as a fungicide in an effectiveness way , without any discontinuous areas • It is environmentally friendly and safe, this cost-effective product is ideal for the qualified or do-it-yourself roofer compared to roof maintenance or replacement,

Open the catalog to page 1

METALNASTRI ANTICORROSION SYSTEMS “Metalnastri Biozinc” is highly malleable and can adopt any shape, including low radius curves and complex shapes unachievable with other materials, allowing for great freedom of design It can be applied in 2 or more layers to guarantee better protection where needed It lasts 10 years or more after the application on the structure. It is advisable a periodic control to evaluate the possible substitution of the coat. It is possible to guarantee a longer duration, operating on the width, according to the client’s needs. MAIN USES “Metalnastri Biozinc” product is...

Open the catalog to page 2

METALNASTRIANTICORROSION SYSTEMS Technical Datasheet

Open the catalog to page 3

All Metalnastri catalogs and technical brochures

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.

Brand list